Subtask 27-44-51-865-052
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/ELAC1/NORM/SPLY 15CE1 B11
 49VU FLIGHT CONTROLS/THS/ACTR/MOT2 19CE2 B09 105VU FLT CTL/ELAC1/STBY SPLY 16CE1 A01 121VU FLIGHT CONTROLS/THS ACTR/MOT3 19CE3 Q17 121VU FLIGHT CONTROLS/THS ACTR/MOT1 19CE1 Q16
 1EFF : ALL 1 27-44-51Page 502 1 1 May 01/05R 1 1 1CES 1

 4. Procedure_________
 (Ref. Fig. 501/TASK 27-44-51-991-011)
 Subtask 27-44-51-710-050
 A. Operational Test
 (1) Cut, remove and discard the lockwire at the plug (3) of the manual drive input.
 (2) Remove the plug (3) from the manual drive input of the THS actuator (1).
 (3) Remove and discard the O-ring (4) from the plug (3). 
R R  (4) Install the RELEASE TOOL - PRESSURE-OFF BRAKE, THS ACTUATOR (0U190844) on the control piston (2) of one of the two pressure-off brakes as follows:
 (a) Install the shaft on the thread of the control piston (2).
 (b) Put the collar in position on the shaft and install the command nut.
 (c) Make sure that the collar has contact with the housing and there is a gap between the spring pin and the collar.
 (d) Make sure that the command nut has contact with the collar.
 (e) TORQUE the command nut to between 0.35 and 0.50 m.daN (30.97 and 44.24 lbf.in) (agrees with half a turn of the command nut) to release the pressure-off brake.
 (5) Put a socket wrench in position at the manual drive input.
 (6) Use the socket wrench to turn the manual drive input (a maximum of half a revolution), very slowly, in one direction and then in the other direction.
 NOTE : Listen for the operation noise of the ratchet wheels, (a____ tic-tac noise), while the manual drive input turns.
 NOTE : When you turn the manual drive input in the clockwise or____ counter- clockwise directions, an intermitted resistance to the movement can occur, due to compression of hydraulic fluid in the hydraulic motors. 
R R  (7) Remove the RELEASE TOOL - PRESSURE-OFF BRAKE, THS ACTUATOR (0U190844) from the control piston (2).

 Location of the Manual Drive Input and the Installation of the Release Tool of
 the Pressure-Off Brake
 Figure 501/TASK 27-44-51-991-011

 1EFF : ALL 1 27-44-51Page 504 1 1 May 01/98R 1 1 1CES 1

 (8)
 Remove the socket wrench from the manual drive input.

 (9)
 Apply COMMON GREASE (Material No. 04-015) to the new O-ring (4).

 (10)
 Use the CONE - MOUNTING, THS ACTUATOR (0U145506) and put the O-ring

 (4) on the plug (3).

 (11)
 Install the plug (3) in the manual drive input.

 (12)
 TORQUE the plug (3) to between 1.4 and 1.6 m.daN (10.32 and 11.79 lbf.ft).

 (13)
 Safety the plug (3) with lockwire, corrosion-resistant steel, dia 0.6 mm (0.024 in.).

 5. Close-up
________ Subtask 27-44-51-865-053
 A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 15CE1, 16CE1, 19CE1, 19CE2, 19CE3.
 Subtask 27-44-51-410-058
 B. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Close the access door 312AR.

 (3)
 Remove the warning notice(s).

 (4)
 Remove the access platform(s).

 1EFF : ALL 1 27-44-51Page 505 1 1 May 01/98R 1 1 1CES 1

 ACTUATOR - THS (9CE) - INSPECTION/CHECK
_______________________________________
 TASK 27-44-51-210-001
 Visual Inspection of the THS-Actuator
 WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______
 ONLY WITH A GOOD SUPPLY OF AIR.
 OBEY THE MANUFACTURERS INSTRUCTIONS.
 PUT ON PROTECTIVE CLOTHING.
 DO NOT GET THEM IN YOUR MOUTH.
 DO NOT SMOKE.
 DO NOT BREATHE THE GAS.
 THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
 GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.

 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
 START A TASK ON OR NEAR:

 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 1. Reason for the Job
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱3(159)