(1)
 Put the ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position at the access door 312AR.

 (a) Open the access door 312AR.

 (2)
 Put the ACCESS PLATFORM 2M (6 FT) in position at the access door 811.

 (a) Open the access door 811 (Ref. TASK 52-41-00-410-002).

 (3)
 Put the ACCESS PLATFORM 2M (6 FT) in position at the access door 812.

 (a) Open the access door 812.

 (4)
 Put the ACCESS PLATFORM 2M (6 FT) in position at the access door 824.

 (a) Open the access door 824.
 1EFF : ALL 1 27-41-00Page 615 1 1 May 01/05R 1 1 1CES 1

 (5)
 Put the ACCESS PLATFORM 2M (6 FT) in position at the access door 825.

 (a) Open the access door 825.

 (6)
 Put the ACCESS PLATFORM 2M (6 FT) in position at the access door 826.

 (a) Open the access door 826. Subtask 27-41-00-860-058
 B. Aircraft Maintenance Configuration
 (1)
 Make sure that the aircraft electrical circuits are de-energized (Ref. TASK 24-41-00-862-002).

 (2)
 Make sure that the air conditioning is de-energized (Ref. TASK 12-33-21-618-001).

 (3)
 The aircraft must stay at least three hours in this configuration in order to get an uniform stabilized temperature.

 (4)
 The ambiant temperature must be within the range of 0 deg.C (32.00 deg.F), 40 deg.C (104.00 deg.F).

 (5)
 The cable routing area must not be lighten by neon located close the cable itself.

 4. Procedure
_________
 (Ref. Fig. 602/TASK 27-41-00-991-007) Subtask 27-41-00-220-050
 A. Check of the Cable Tension Regulator of the THS Trim Control (Pointer in the Limits)
 (1)
 Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).

 (2)
 Pressurize the Green and Yellow hydraulic systems (Ref. TASK 29-23-00-863-001) and (Ref. TASK 29-24-00-863-001).

 (3)
 Operate the THS more than ten times and put it in the zero position.

 (4)
 Install the PIN - RIGGING (0U190360) (1) on the input shaft of the THS actuator.

 1EFF : ALL 1 27-41-00Page 616 1 1 May 01/05R 1 1 1CES 1

 THS Actuator - Rigging Figure 602/TASK 27-41-00-991-007
 1EFF : 1 1R 1CES  ALL  1 11 1 27-41-00 Page 617 May 01/05

 (5)
 Depressurize the Green and Yellow hydraulic systems (Ref. TASK 29-23-00-864-001).

 (6)
 De-energize the aircraft electrical circuit (Ref. TASK 24-41-00-862-002).

 (7)
 Put a warning notice on the pitch-trim control wheels to tell persons not to use the pitch trim.

 (8)
 Bend the two cables to the same value and release them quickly. When you release the cables, make sure that the movable pulley bracket of the tension regulator moves easily (it must not be caught).

 (9)
 Measure the ambient temperature with a thermometer.

 (10)
 Use the adjustment graph to find the position of the index in relation to the measured ambient temperature. (Ref. Fig. 603/TASK 27-41-00-991-009)

 (11)
 Make sure that the position of the index agrees with the value found on the graph with a tolerance of + or - 1 graduation (+ or - 5 deg C).

 (12)
 If the result of the check is no correct, adjust the THS cable length (Ref. TASK 27-41-00-820-002).

 5. Close-up
________ Subtask 27-41-00-860-059
 A. Put the aircraft back to its initial configuration.
 (1) Remove the PIN - RIGGING (0U190360).
 (2) Remove the warning notice. Subtask 27-41-00-410-051
 B. Close Access
 (1)
 Close the access doors 312AR, 824, 825, 826, 811, 812 (Ref. TASK 52-41-00-410-002).

 (2)
 Remove the access platform(s).

 (3)
 Make sure that the work area is clean and clear of tool(s) and other items.

 1EFF : ALL 1 27-41-00Page 618 1 1 May 01/05R 1 1 1CES 1

 Adjustment Graph Figure 603/TASK 27-41-00-991-009
 1EFF : 1 1R 1CES  ALL  1 11 1 27-41-00 Page 619 May 01/05

 TASK 27-41-00-220-002 Check of the Correct Tension of the THS Mechanical Control Cables WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 WARNING : MAKE SURE THAT THE CONTROLS AGREE WITH THE POSITION OF THE ITEMS THEY
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱3(98)