(2)
Install the pneumatic right-angle wrench on the ADAPTOR-DRIVE, SLAT (AND FLAP).
(3)
Extend the flaps with the ADAPTOR-DRIVE, SLAT (AND FLAP) and pneumatic right-angle wrench as necessary.
Subtask 27-50-00-866-059
B. Manual Extension of the Flaps without Pneumatic Wrench WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(1)
Install the BAR-TURNING (98D27804011000) on the flap drive shaft, outboard of the right angle gearbox 6203CM (6253CM).
(2)
Extend the flaps with the BAR-TURNING as necessary.
1EFF : ALL 1 27-50-00Page 213 1 1 May 01/04R 1 1 1CES 1
Flaps - Manual Extension/Retraction Figure 201/TASK 27-50-00-991-005
1EFF : 1 1R 1CES ALL 1 11 1 27-50-00 Page 214 May 01/04
TASK 27-50-00-866-009
Retraction of the Flaps on the Ground
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
To retract the flaps without movement of the slats. To retract the flaps and slats at the same time (Ref. TASK 27-50-00-866-00901).
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific warning notice(s)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 27-00-00-080-002 Removal of the Flap/Slat Control-Lever Locking Tool
(98D27803000000) 29-10-00-863-002 Pressurize the Yellow Hydraulic System 29-10-00-864-002 Depressurize the Yellow Hydraulic System 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure
1EFF : ALL 1 27-50-00Page 215 1 1 May 01/04R 1 1 1CES 1
3. Job Set-up
__________
Subtask 27-50-00-941-053
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Put the warning notice(s) in position to tell persons that the flap system is in operation.
Subtask 27-50-00-865-057
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 5CV B06 R 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 7CV R21
Subtask 27-50-00-860-056
C. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES
_______ ARE CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Pressurize the Yellow hydraulic system (Ref. TASK 29-10-00-863-002). NOTE : The flaps move at full-speed if the Power Transfer Unit (PTU),
____ is in operation. If the PTU is isolated (electrically or hydraulically) only the yellow flap motor operates and the flaps move at half-speed.
NOTE : An ECAM F/CTL FLAP SYS 1 FAULT message will show when the PTU
____ is isolated. This message can be ignored.
Subtask 27-50-00-865-058
D. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/WTB/FLP/SYS2 12CV P20 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21 122VU FLIGHT CONTROLS/WTB/FLP/SYS1 10CV S07
4. Procedure
_________ Subtask 27-50-00-866-053
A. Retraction of the Flaps on the Ground WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM FLIGHT CONTROLS 飛行操縱3(193)
