1EFF : ALL 1 27-34-00Page 504 1 1 Feb 01/99R 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
10. On the panel 23VU:
-Push the FLT CTL/SEC1 pushbutton switch.
11. On the panel 24VU:
-Push the FLT CTL/SEC2 pushbutton switch.
12. On the panel 23VU:
-Push the FLT CTL/ELAC1 pushbutton switch.
On the lower ECAM display unit,on the F/CTL page:
-
The SEC1 indication becomes amber.
-
The indication of the elevator position is in amber crosses.
On the ground, visually make sure that the elevators are in the neutral position.
On the panel 23VU:
-
The OFF legend of the FLT CTL/SEC1pushbutton switch goes off.
-
The FAULT legend comes on then goes off.
On the lower ECAM display unit, on the F/CTL page:
-
The SEC1 indication becomes green.
On the panel 24VU:
-
The OFF legend of the FLT CTL/SEC2pushbutton switch goes off.
-
The FAULT legend comes on then goes off.
On the lower ECAM display unit on the F/CTL page:
-
The SEC2 indication becomes green.
On the panel 23VU:
-
The OFF legend of the FLT CTL/ELAC1pushbutton switch goes off.
-
The FAULT legend comes on then goes off.
On the lower ECAM display unit on the F/CTL page:
-
The ELAC1 indication becomes green.
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
13. On the panel 24VU: On the panel 24VU:
-Push the FLT CTL/ELAC2 - The OFF legend of the FLT CTL/ELAC2 pushbutton switch. pushbutton switch goes off.
-
The FAULT legend comes on then goes off.
On the lower ECAM display unit on the F/CTL page:
-
The ELAC2 indication becomes green.
5. Close-up
________ Subtask 27-34-00-860-055
A. Put the Aircraft back to its Initial Configuration.
(1)
Depressurize the aircraft hydraulic systems (Ref. TASK 29-23-00-864-001) (Ref. TASK 29-24-00-864-001) (Ref. TASK 29-10-00-864-003).
(2)
Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
(3)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
Subtask 27-34-00-410-062
B. Close Access
(1)
Install the protective cover on the battery power center 105VU.
(2)
Thigthen the two screws.
(3)
Close the access door 822.
(4)
Remove the access platform(s).
TASK 27-34-00-710-002
Operational Test of the Centering Function
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE CLEAR._______ MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND THE RELATED DOORS - COMPONENTS THAT MOVE.
1. Reason for the Job__________________
Self Explanatory
2. Job Set-up Information______________________
R A. Fixtures, Tools, Test and Support Equipment
R R R -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
R No specific access platform 1.6 m (5 ft. 3 in.)
R B. Referenced Information
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱3(20)
