(3)
Open the applicable MLG door zone 734(744) (Ref. TASK 32-12-00-010-001).
(4)
Make sure that the GROUND LOCK SLEEVE is on the applicable MLG door actuating cylinder.
(5)
Remove the No. 2 flap track movable fairing, but do not retract the flaps or remove the fixed fairings (Ref. TASK 57-55-11-000-001).
(6)
Remove the applicable access panel, 573BB or 673BB (Ref. TASK 57-51-37-000-002).
**ON A/C 301-399,
Subtask 27-54-55-010-050-A
D. Get Access
(1)
Put the access platform in position below the applicable zone 573 or
673.
(2)
If necessary, remove the applicable access panels (Ref. TASK 57-55-11-000-004):
-
for the LH flap-actuator lever assembly, remove 193AB, 193BB
-
for the RH flap-actuator lever assembly, remove 194AB, 194BB.
(3)
Open the applicable MLG door zone 734(744) (Ref. TASK 32-12-00-010-001).
(4)
Make sure that the GROUND LOCK SLEEVE is on the applicable MLG door actuating cylinder.
(5)
Remove the No. 2 flap track movable fairing, but do not retract the flaps or remove the fixed fairings (Ref. TASK 57-55-11-000-004).
(6)
Remove the applicable access panel, 573BB or 673BB (Ref. TASK 57-51-37-000-002).
**ON A/C ALL
Subtask 27-54-55-480-050
E. Installation of Support Equipment
(1)
Install a LOCK-TORQUE SHAFT (FLAPS AND SLATS) WITH CLAMP-PIVOT (98D27504030001) on the torque shafts outboard of the Track 2 actuator (Ref. TASK 27-50-00-400-003).
(2)
Install the inboard flap hoisting sling (Ref. TASK 27-50-00-400-002).
Subtask 27-54-55-020-055
F. Remove the Applicable Actuator:
-
for the Track 1 actuator lever remove, 6205CM (6255CM) (Ref. TASK 27-54-49-000-001)
-
for the Track 2 actuator lever remove, 6211CM (6261CM) (Ref. TASK 27-54-49-000-002).
1EFF : ALL 1 27-54-55Page 405 1 1 Aug 01/05R 1 1 1CES 1
4. Procedure_________ **ON A/C 001-049, 051-061, 101-103, 201-203,
R (Ref. Fig. 401/TASK 27-54-55-991-001) **ON A/C 062-099, 104-105, 151-158, 204-210,
R (Ref. Fig. 401A/TASK 27-54-55-991-001-A) **ON A/C 106-149, 159-199, 211-299, 401-499,
R R (Ref. Fig. 401B/TASK 27-54-55-991-001-C) **ON A/C 301-399,
R R (Ref. Fig. 401C/TASK 27-54-55-991-001-B) **ON A/C 001-049, 051-099, 101-105, 151-199, 201-212,
R (Ref. Fig. 402/TASK 27-54-55-991-004) **ON A/C 106-149, 213-299, 401-499,
R R (Ref. Fig. 402A/TASK 27-54-55-991-004-B) **ON A/C 301-399,
R (Ref. Fig. 402B/TASK 27-54-55-991-004-A) **ON A/C ALL
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______ EDGE: - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R 1EFF : ALL 1 27-54-55Page 406 1 1 Aug 01/05 1 1 1CES 1
Flap Actuator Lever - Track 1
Figure 401/TASK 27-54-55-991-001
R 1EFF : 001-049, 051-061, 101-103, 201-203, 1 27-54-55Page 407 1 1 Aug 01/05 1 1 1CES 1
Flap Actuator Lever - Track 1 Figure 401A/TASK 27-54-55-991-001-A
R 1EFF : 062-099, 104-105, 151-158, 204-210, 1 27-54-55Page 408 1 1 Aug 01/05 1 1 1CES 1R Flap Actuator Lever - Track 1 R Figure 401B/TASK 27-54-55-991-001-C
R 1EFF : 106-149, 159-199, 211-299, 401-499, 1 27-54-55Page 409 1 1 Aug 01/05 1 1 1CES 1
Flap Actuator Lever - Track 1
R Figure 401C/TASK 27-54-55-991-001-B
R 1EFF : 301-399, 1 27-54-55 Page 410
1 1 Aug 01/05
1 1
1CES 1
Flap Actuator Lever - Track 2
Figure 402/TASK 27-54-55-991-004
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 27-54-55Page 411 1201-212, 1Aug 01/05 1 1 1CES 1R Flap Actuator Lever - Track 2 R Figure 402A/TASK 27-54-55-991-004-B
R 1EFF : 106-149, 213-299, 401-499, 1 27-54-55Page 412 1 1 Aug 01/05 1 1 1CES 1
Flap Actuator Lever - Track 2
R Figure 402B/TASK 27-54-55-991-004-A
R 1EFF : 301-399, 1 27-54-55 Page 413
1 1 Aug 01/05
1 1
1CES 1
**ON A/C 001-049, 051-061, 101-103, 201-203,
Subtask 27-54-55-020-053
R A. Removal of the Flap-Actuator Lever Assembly - Track 1
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM FLIGHT CONTROLS 飛行操縱5(165)
