SFCC 1
 PPU DATE (DEG) DATE:XXX XX UTC:XXXX LH APPU FPPU RH APPU ***.* ***.* ***.* ***HEX ***HEX ***HEX ***
 OTHER SFCC LH APPU FPPU RH APPU ***.* ***.* ***.* *** ***HEX ***HEX ***HEX
 <RETURN PRINT>
 Table 1 PPU DATA (DEG) displayed on the MCDU at the flap position FULL
R 1EFF : ALL 1 27-54-49Page 405 1 1 Aug 01/02 1 1 1CES 1

 Subtask 27-54-49-020-063 R B. Preparation for Removal of the Flap Track 1 to 4 Actuators
 (1) Hold the trailing edges of the inboard and outboard flaps on supports.
R  (2) Use clamps to hold the flap carriages in position. NOTE : This is to make sure that the flap carriages do not move.
____
 (3)
 Measure and write down the dimension 'A' between the actuator lever and its stop face.

 (4)
 Remove the asymmetry-position pick-off unit from the flap track 4 actuator (Ref. TASK 27-51-18-000-001).

 NOTE : The unit will be locked in the extended position and must not
____
 be adjusted.

 Subtask 27-54-49-020-062
 C. Removal of the Flap Track 1 to 4 Actuators
 (1) Remove the flap track 1 to 4 actuators in sequence (Ref. TASK 27-54-49-000-001), (Ref. TASK 27-54-49-000-002), (Ref. TASK 27-54-49-000-003) and (Ref. TASK 27-54-49-000-004).

 TASK 27-54-49-400-005
 Installation of the Flap Track 1 to 4 Actuators 6205CM(6255CM)/6211CM(6261CM)/ 6221CM(6271CM)/6233CM(6283CM)
 WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______ NOTICES ARE IN POSITION.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platforms No specific safety barriers No specific warning notice
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power 27-50-00-866-008 Extension of the Flaps on the Ground 27-51-18-400-001 Installation of the Asymmetry-Position Pick-Off Unit
 29CV (30CV) 27-54-00-710-001 Operational Test of the Flap System
 1EFF : ALL 1 27-54-49Page 407 1 1 May 01/05R 1 1 1CES 1

 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
27-54-49-400-001 Installation of the Flap Track 1 Actuator
 6205CM(6255CM)
 27-54-49-400-002 Installation of the Flap Track 2 Actuator
 6211CM(6261CM)
 27-54-49-400-003 Installation of the Flap Track 3 Actuator
 6221CM(6271CM)
 27-54-49-400-004 Installation of the Flap Track 4 Actuator

 6233CM(6283CM) 27-60-00-866-002 Extension-Retraction of the Spoilers for Maintenance 31-32-00-860-006 Procedure to Get Access to the SYSTEM REPORT/TEST
 F/CTL Page 32-00-00-481-001 Installation of the Safety Devices on the Landing
 Gears
 32-12-00-010-001 Open the Main Gear Doors for Access
 32-12-00-410-001 Close the Main Gear Doors after Access

 **ON A/C 001-049, 051-099, 101-149, 201-299,
 27-54-49-991-008 Fig. 401

R **ON A/C 151-199, 401-499,
 27-54-49-991-008-A Fig. 401A
 **ON A/C 301-399,
 27-54-49-991-008-B Fig. 401B
 **ON A/C ALL
 3. Job Set-up
__________
 Subtask 27-54-49-941-077
 A. Safety Precautions
 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.

 (1)
 Make sure that the safety barriers are in position.

 (2)
 Make sure that the warning notice are in position to tell persons not to operate the flaps.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱5(98)