(4)
 Install the bolts (4), the washers (11), the nuts (12) and tighten them. Safety the nuts (12) with new cotter pins (13).

 1EFF : 401-499, 1 32-43-47Page 405 1 1 Aug 01/05 1 1 1CES 1

 (5)
 Align the rods (7) with the levers (2).
 Install the bolts (5), the washers (8) and the nuts (9).

 (6)
 Tighten the nuts (9) and safety them with new cotter pins (10).

 (7)
 Remove the blanking caps from the electrical connectors.

 (8)
 Make sure that the electrical connectors are clean and in the correct condition.

 (9)
 Connect the electrical connectors (14) to the transmitter unit (3).

 (10) Remove the PIN, RIGGING - RUDDER CONTROL (1). Subtask 32-43-47-865-052
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU ABCU &/Y BRK/PRESS IND 61GG C10 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33 121VU ABCU/HOT BUS/SPLY 110GG P30
 Subtask 32-43-47-710-050
 C. Test
 (1) Do the operational test of the alternate braking system (Ref. TASK 32-43-00-710-001).
 5. Close-up
________ Subtask 32-43-47-862-050
 A. Put the aircraft back to its initial configuration.
 (1) Remove the warning notice(s).
 1EFF : 401-499, 1 32-43-47Page 406 1 1 Aug 01/05 1 1 1CES 1 Subtask 32-43-47-410-050

 B. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Close the access door 811.

 (3)
 Remove the access platform(s).

 (4)
 De-energize the ground service network (Ref. TASK 24-42-00-862-001).

 1EFF : 401-499, 1 32-43-47Page 407 1 1 Aug 01/05 1 1 1CES 1

 SELECTOR VALVE - ALTERNATE BRAKE (99GG) - REMOVAL/INSTALLATION
______________________________________________________________
 TASK 32-43-51-000-001 Removal of the Alternate Braking Selector Valve WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______ YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE. WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
 No specific 1 ACCESS PLATFORM 2M (6 FT)
 No specific 1 CONTAINER 5 L(1 1/2 USGAL)
 No specific 6 PLUG - BLANKING

 1EFF : 401-499, 1 32-43-51Page 401 1 1 Aug 01/05 1 1 1CES 1 B. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
20-23-21-911-001  Removal/Installation of the Bobbins from their Housings and Installation of O-rings, Square Seals, and Back-up Rings on the Bobbins
 29-00-00-910-002 Safety Procedures of the Hydraulic System 29-10-00-864-002 Depressurize the Yellow Hydraulic System 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-23-00-860-001 Disconnection of the Isolation Coupling of the Power
 Transfer Unit (PTU) 32-12-00-010-001 Open the Main Gear Doors for Access 32-44-11-200-001 Check Nitrogen Charge Pressure On Parking/Emergency
 Accumulator By Reading Gauge 32-43-51-991-001 Fig. 401
 3. Job Set-up
__________
 Subtask 32-43-51-860-050
 A. Aircraft Maintenance Configuration
 WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
 (1)
 Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).

 (2)
 Depressurize the Yellow hydraulic system (Ref. TASK 29-10-00-864-002).
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊(cè) AMM LANDING GEAR 起落架7(111)