(3)
 Push the pressure release button on the pressure relief valve 3067GM to depressurize the alternate brake system.

 (4)
 Make sure that the pressure on the gauge 2585GM decreases to the fill pressure of the accumulator 2582GM (Ref. TASK 32-44-11-200-001).

 (5)
 Disconnect the PTU isolation coupling:

 (a)
 Depressurize the reservoir of the Yellow hydraulic system (Ref. TASK 29-14-00-614-001).

 (b)
 Disconnect the PTU isolation coupling (Ref. TASK 29-23-00-860-001).

 (6)
 Put the ACCESS PLATFORM 2M (6 FT) in position.

 1EFF : 401-499, 1 32-43-51Page 402 1 1 Aug 01/05 1 1 1CES 1

 (7)
 Put the CONTAINER 5 L(1 1/2 USGAL) below the manifold 3016GM to collect the hydraulic fluid leakage.

 (8)
 Do the safety precautions:

 (a) Put the WARNING NOTICE in position to tell persons not to pressurize the Yellow hydraulic system: - on the panel 40VU in the cockpit, - on the ground service panel of the Yellow hydraulic system.
 Subtask 32-43-51-010-050
 B. Get Access
 (1) Open the right MLG door (Ref. TASK 32-12-00-010-001)
 Subtask 32-43-51-865-050
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU ABCU &/Y BRK/PRESS IND 61GG C10 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33 121VU HYDRAULIC/PARK BRK/CTL/STBY 71GG N37 121VU HYDRAULIC/PARK BRK/CTL/NORM 70GG N36 121VU HYDRAULIC/HYD POWER/Y 3803GX N30 121VU HYDRAULIC/Y HYD/PUMP ENG2/MONG 3700GD Q37 121VU HYDRAULIC/Y HYD/PUMP ENG2/CTL 3701GD Q36 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 1EFF : 401-499, 1 32-43-51Page 403 1 1 Aug 01/05 1 1 1CES 1

 4. Procedure
_________
 (Ref. Fig. 401/TASK 32-43-51-991-001) Subtask 32-43-51-020-050
 A. Removal of the Alternate Braking Selector Valve
 (1)
 Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).

 (2)
 Disconnect the electrical connector (10).

 (a)
 Install a PLUG - BLANKING on the electrical connector (10).

 (b)
 Install a PLUG - BLANKING on the electrical receptacle of the alternate braking selector valve (12).

 (3)
 Remove the bolt (11), the washer (8) and the bonding lead (7).

 (4)
 Remove the bolts (9), the washers (8) and the alternate braking selector valve (12) from the manifold assembly (1).

 (5)
 Remove the bobbins (4) (Ref. TASK 20-23-21-911-001).

 (6)
 Install a PLUG - BLANKING in each of the open ports of the alternate braking selector valve (12) and the manifold assembly (1).

 1EFF : 401-499, 1 32-43-51Page 404 1 1 Aug 01/05 1 1 1CES 1

 Alternate Brake Selector Valve
 Figure 401/TASK 32-43-51-991-001
 1EFF :  401-499,  1  32-43-51 Page 405 
1  1  Aug 01/05
 1  1
 1CES  1

 TASK 32-43-51-400-001
 Installation of the Alternate Braking Selector Valve
 WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK AREA WHEN
_______ YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
 WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THIS/THESE
_______ MATERIAL/S. USE PROTECTIVE CLOTHING, RUBBER GLOVES AND A MASK.
 WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______ YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
 1. Reason for the Job
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架7(112)