(3)
 Disconnect the isolation coupling of the PTU (Ref. TASK 29-23-00-860-001).

 1EFF : ALL 1 32-42-16Page 423 1 1 Nov 01/04R 1 1 1CES 1

 4. Procedure
_________ R **ON A/C 001-002, 051-052,
 (Ref. Fig. 403/TASK 32-42-16-991-003) **ON A/C ALL R Post SB 32-1190 For A/C 001-002,051-052, (Ref. Fig. 404/TASK 32-42-16-991-004) **ON A/C ALL
 Subtask 32-42-16-020-051
 A. Removal of the Normal-Brake Servovalve Manifold Filter WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
_______
 -FLUSH IT AWAY WITH CLEAN WATER
 -GET MEDICAL AID. CAUTION : MAKE SURE THAT THE FLUID DOES NOT STAY ON THE AIRCRAFT
_______ STRUCTURE. IF THE FLUID GETS ON THE AIRCRAFT STRUCTURE, WASH IT OFF IMMEDIATELY WITH SOAP AND WATER.
 (1)
 Remove and discard the locking wire from the plug (1) and then remove the plug (1).

 (2)
 Remove and discard the retainer (2) and the packing (3) from the plug (1).

 (3)
 Carefully remove and discard the filter (4) and the packing (5) from the manifold.

 1EFF : ALL 1 32-42-16Page 424 1 1 May 01/05 1 1 1CES 1R Normal-Brake Servovalve - Filter Installation Detail R Figure 404/TASK 32-42-16-991-004

 1EFF : ALL 1 32-42-16Page 425 1 1 Nov 01/04 1 1 1CES 1 TASK 32-42-16-400-002

 Installation of the Normal-Brake Servovalve Manifold Filter
 WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______ NOTICES ARE IN POSITION.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific warning notice No specific warning notices No specific Torque Wrench : range 2.00 to 20.00 m.daN
 (15.00 to 150.00 lbf.ft) S16-0609-0872 1 BULLET SEAL
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1 SOLVENT GENERAL PURPOSE (Ref. 20-31-00) Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
 Material No. 19-010  USA AMS 5687 LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA (Ref. 20-31-00)
 1EFF : ALL 1 32-42-16Page 426 1 1 Nov 01/04R 1 1 1CES 1

 C. Expendable Parts
 -------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
R R R R R  1 1 2 2 3 3 4 4 5 5  plug plug retainer retainer packing packing filter filter packing packing  32-42-16 02A-090 32-42-16 02C-09032-42-16 02A-100 32-42-16 02C-10032-42-16 02A-110 32-42-16 02C-11032-42-16 02A-120 32-42-16 02C-12032-42-16 02A-130 32-42-16 02C-130
 D. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
29-10-00-864-001 29-14-00-614-001 29-23-00-860-001 29-23-00-860-002 32-00-00-481-001 32-42-00-710-001 32-42-00-710-003 32-42-00-870-001 TFU 324216001  Depressurize the Green Hydraulic SystemDepressurization of the Hydraulic ReservoirsDisconnection of the Isolation Coupling of the Power Transfer Unit (PTU)Connection of the Isolation Coupling of the Power Transfer Unit (PTU)Installation of the Safety Devices on the Landing GearsOperational Check of the Normal Braking SystemOperational Check of Antiskid InhibitionBleeding of the Normal Braking at the Brake Units(for corrective action)
 **ON A/C 001-002, 051-052,
 32-42-16-991-003  Fig. 403

 1EFF : ALL 1 32-42-16Page 427 1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL

 3. Job Set-up
__________ **ON A/C 001-002, 051-052,
 (Ref. Fig. 403/TASK 32-42-16-991-003) **ON A/C ALL
 Subtask 32-42-16-941-053
 A. Safety Precautions
 (1)
 Make sure that the safety barriers are in position.

 (2)
 Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).

 (3)
 On the panel 400VU:

 -
make sure that the landing-gear control-lever 6GA is in the DOWN position
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架7(9)