A. Aircraft Maintenance Configuration
(1)
On the AIR COND overhead panel 225VU:
-release the PACK 1 and PACK 2 pushbutton switches to off (the OFF legends come on).
-make sure that the X-bleed selector switch is in the AUTO position.
(2)
Do the EIS stop procedure
(Ref. TASK 31-60-00-860-002).
(3)
De-energize the aircraft electrical circuits
(Ref. TASK 24-41-00-862-002).
(4)
If the access door 811 is open:
-Remove the warning notice(s).
-Close the access door 811 (Ref. TASK 52-41-00-410-002).
TASK 36-12-00-860-002 Pressurization of the Bleed System through the HP Ground Connector
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific ground air-supply unit No specific warning notice
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure 52-41-00-010-002 Open the Avionics Compartment Doors for Access 52-41-00-410-002 Close the Avionics Compartment Doors after Access
3. Job Set-up
__________ Subtask 36-12-00-941-050
A. Safety Precautions WARNING : MAKE SURE THAT THE FWD AVIONICS ACCESS DOOR 811 IS OPEN. WITH A
_______ WARNING PLACARD ATTACHED TO IT. THE WARNING NOTICE MUST TELL PERSONS NOT TO CLOSE THE DOOR. THIS PREVENTS ACCIDENTAL PRESSURIZATION OF THE AIRCRAFT.
(1) When you operate the air condioning make sure that the access door 811 is open (Ref. TASK 52-41-00-010-002).
1EFF : ALL 1 36-12-00Page 205 1 1 Aug 01/02R 1 1 1CES 1
(2) Install a warning notice on the access door 811 to tell persons not to close the access door 811.
Subtask 36-12-00-860-056
B. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002).
(2)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(3)
On the AIR COND overhead panel 225VU:
-release the PACK 1 and PACK 2 pushbutton switches to off (the OFF legends come on).
-make sure that the X-bleed selector switch is in the AUTO position. Subtask 36-12-00-865-054
C. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
122VU AIR BLEED/X FEED VALVE/NORM 1HV Z20
Subtask 36-12-00-010-051
D. Get Access
(1)
Open the access door 191BB.
(2)
Connect the ground air-supply unit to the aircraft HP connector 7300HM.
1EFF : ALL 1 36-12-00Page 206 1 1 Aug 01/02R 1 1 1CES 1
4. Procedure
_________ Subtask 36-12-00-869-056
A. Pressurization of the Bleed System through the HP Ground Connection
(1)
Start the ground air-supply unit and make sure that:
-
the airflow is between 54 kg.min (119.0495 lb.min) and 78 kg.min (171.9605 lb.min),
-
the supplied air pressure is not more than 3.5 bar (50.7631 psi),
-
the supplied air temperature does not go above 260 deg.C (500.00 deg.F).
(2)
On the ECAM control panel, push the BLEED key (the BLEED page comes into view).
(3)
On the AIR BLEED page of the ECAM lower DU, make sure that all indications are shown is normal (i.e. green indication).
(4)
When the pressurization of the bleed system is no longer necessary, stop the air supply.
5. Close-up
________ Subtask 36-12-00-860-057
A. Aircraft Maintenance Configuration
(1)
On the AIR COND overhead panel 225VU:
-release the PACK 1 and PACK 2 pushbutton switches to off (the OFF legends come on). 中國航空網(wǎng) www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM PNEUMATIC 氣源 2(58)
