D. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
 the External Power 28-00-00-910-001 Fuel Safety Procedures 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
 Configuration before Maintenance Action 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
 the Ground Connector 49-00-00-710-004 Operational Test of the APU (4005KM) (GTCP 36-300) 49-90-00-600-001 Check Oil Level and Replenish (GTCP 36-300) 52-41-00-010-001 Open the APU Doors for Access 52-41-00-410-001 Close the APU Doors after Access 49-91-52-991-001 Fig. 401
 3. Job Set-up
__________
 Subtask 49-91-52-941-051
 A. Safety Precautions
 (1) Obey the Fuel Safety Precautions (Ref. TASK 28-00-00-910-001).
 Subtask 49-91-52-860-051
 B. Aircraft Maintenance Configuration
 (1)
 Energize the ground service network
 (Ref. TASK 24-42-00-861-001).

 (2)
 On the panel 25VU make sure that the APU MASTER SW p/bsw is OFF.

 (3)
 Make sure that there is a warning notice in the cockpit to tell persons not to start the APU.

 (4)
 Make sure that hydraulic systems are depressurized
 (Ref. TASK 29-00-00-864-001).

 Subtask 49-91-52-865-051
 C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41
 Subtask 49-91-52-010-057
 D. Get Access
 (1)
 Put the access platform in position below the APU access doors 315AL and 316AR.

 (2)
 Open the APU access doors 315AL and 316AR (Ref. TASK 52-41-00-010-001).

 (3)
 Set the LIGHT SW 11LJ to the ON position.

 4. Procedure
_________ (Ref. Fig. 401/TASK 49-91-52-991-001) Subtask 49-91-52-420-050
 A. Installation of the Generator Scavenge Pump (8085KM)
 (1)
 Remove the blanking caps from the component mating faces.

 (2)
 Clean the component interface and/or the adjacent area.

 (3)
 Do an inspection of the component interface and/or the adjacent area.

 (4)
 Apply a thin layer of OILS (Material No. 03-002) to the new O-ring

 (5) and the new O-ring (4).

 (5)
 Install the new O-rings (5) and (4) to the generator scavenge pump (8085KM) (3).

 (6)
 Hold the generator scavenge pump (8085KM) (3) in position and install the washers (2)

 (7)
 TORQUE the bolts (1) to 0.56 m.daN (49.55 lbf.in). and the bolts (1).

 (8)
 Apply a thin layer of OILS (Material No. 03-002) to the new O-ring

 (7) and the new O-ring (8).

 (9)
 Install the new O-rings (7) and (8) to the generator (9).

 (10)
 Put the generator (9) in position onto the accessory drive gearbox.

 (11)
 Turn the generator (9) clockwise to engage the accessory-drive gearbox studs in the correct position.

 (12)
 Make sure that the dowel on the accessory drive gearbox-flange engages fully in the generator (9).

 (13)
 TORQUE the nuts (6) to between 3.9 and 4.4 m.daN (28.76 and 32.44 lbf.ft).

 (14)
 Remove the blanking caps from the electrical connections.

 (15)
 Connect the electrical connection (12).

 (16)
 Install the electrical connections (13) with the washers (14) and the nuts (15).

 (17)
 TORQUE the nuts (15) to between 1.6 and 1.9 m.daN (11.79 and 14.01 lbf.ft).

 (18)
 Install the cover plate (16) with the washers (17) and the screws (18).

 (19)
 TORQUE the screws (18) to between 0.43 and 0.47 m.daN (38.05 and

 41.59 lbf.in). Subtask 49-91-52-210-051
 B. Do a visual check of the oil quantity. Add oil if the oil level is on or less than the ADD mark on the sight glass (Ref. TASK 49-90-00-600-001).
 Subtask 49-91-52-865-052
 C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1KD, 2KD.
 Subtask 49-91-52-410-052
 D. Close the APU access doors 315AL, 316AR (Ref. TASK 52-41-00-410-001).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 機載輔助動力 AIRBORNE AUXILIARY POWER 6(153)