(2)
Remove the warning notice(s).
(3)
Make sure that the work area is clean and clear of tool(s) and other items.
R 1EFF : 151-199, 401-499, 1 27-64-00Page 541 1 1 Aug 01/05 1 1 1CES 1 Subtask 27-64-00-410-058
B. Close Access
(1)
Install the protective cover on the battery power center 105VU.
(2)
Tighten the two screws.
(3)
Close the access door 822.
(4)
Close these access doors :
(a)
573BB for the left spoiler 1.
(b)
575BB for the left spoiler 2.
(c)
575DB for the left spoiler 3.
(d)
575EB for the left spoiler 4.
(e)
575GB for the left spoiler 5.
(f)
673BB for the right spoiler 1.
(g)
675BB for the right spoiler 2.
(h)
675DB for the right spoiler 3.
(i)
675EB for the right spoiler 4.
(j)
675GB for the right spoiler 5.
(5) Remove the access platform(s). Subtask 27-64-00-862-060
C. De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
R 1EFF : 151-199, 401-499, 1 27-64-00Page 542 1 1 Aug 01/05 1 1 1CES 1 SPOILER HYDRAULIC ACTUATION - INSPECTION/CHECK
______________________________________________
TASK 27-64-00-200-001
Check of the Spoilers Servo Controls and Hinge Bearings for Excessive Play and Condition
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE
_______
CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
WARNING : MAKE SURE THERE ARE NO PERSONS OR EQUIPMENT NEAR THE SLATS. THE SLATS
_______
WILL MOVE WITH THE FLAPS.
1. Reason for the Job
__________________
Refer to the MPD TASK: 276400-02
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific corner plate
No specific graduated scale
No specific warning notice(s)
No specific access platform 3.5 m (11 ft. 6 in.)
R 97A27003000000 1 GAGE ASSY - PUSH-PULL
R 97A27003000001 1 GAGE ASSY - PUSH-PULL 97A27902016000 1 SPRING SCALE ASSY 98D27603001000 1 LOAD APPLICATION TOOL - SPOILER 98D27803000000 1 LOCKING TOOL - FLAP/SLAT CONTROL LEVER 98D27903500000 2 PIN-SIDE STICK LOCKING B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power
27-50-00-866-008 Extension of the Flaps on the Ground
27-50-00-866-009 Retraction of the Flaps on the Ground
27-64-41-200-001 Inspection/Check of the Spoiler 1
27-64-42-200-001 Inspection/Check of the Spoiler 2
27-64-43-200-001 Inspection/check of the Spoiler 3
27-64-44-200-001 Inspection/Check of the Spoiler 4
27-64-45-200-001 Inspection/Check of the Spoiler 5
R 29-10-00-863-003 Pressurize the Blue Hydraulic System with a Ground
R Power Supply 29-10-00-864-003 Depressurize the Blue Hydraulic System 29-23-00-863-001 Pressurize the Green Hydraulic System from the Yellow Hydraulic System through the PTU with the Electric Pump 29-23-00-864-001 Depressurize the Green and Yellow Hydraulic Systems after Operation of the PTU 29-24-00-863-001 Pressurize the Yellow Hydraulic System with the Electric Pump 29-24-00-864-001 Depressurize the Yellow Hydraulic System 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure 27-64-00-991-005 Fig. 601
3. Job Set-up
__________
Subtask 27-64-00-860-054
A. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱6(118)
