3. Job Set-up
__________
Subtask 53-15-11-869-051
A. Aircraft Maintenance Configuration
(1)
Make sure that the access platform is in position.
(2)
Make sure that the warning notice is in position in the cockpit to tell persons not to operate the radar system.
Subtask 53-15-11-865-056
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
R **ON A/C 051-099,
R 121VU COM NAV/RADAR/2 5SQ2 K14 R **ON A/C ALL
Subtask 53-15-11-820-053
C. Adjustment of the Rods.
(Ref. Fig. 408/TASK 53-15-11-991-005)
(1)
Adjust the rod (4).
(2)
Unscrew the nut (12)
(3)
Pull up the bush (13) and extend the rod (4).
(4)
Push down the bush (13) to lock the rod in the extended position.
(5)
Adjust the center-to-center distance to L=544 +1 -1 mm (21.4173 +0.0393 -0.0393 in.) by acting on eye end (11).
(6)
Tighten down nut (12).
EFF : ALL
53-15-11Page 426
Subtask 53-15-11-640-051
D. Lubrication.
(1) Lubricate the bolts and the ends of the rod (4) with the COMMON GREASE (Material No. 04-004).
4. Procedure
_________ Subtask 53-15-11-420-051
A. Installation of the Rods.
(Ref. Fig. 401/TASK 53-15-11-991-001, 408/TASK 53-15-11-991-005)
(1)
Install the adjusted rod (4) on the support (1).
(2)
Install the bolt (2) with the head on the outer side of the aircraft.
(3)
Install the nut (8).
(4)
Tighten the nut (8).
(5)
Install the cotter pin (18) (9).
(6)
Put the rod (4) on the support of the fuselage.
(7)
Install the bolt (3) with the head on the outer side of the aircraft. If it is necessary, pull the heads of the rods to install the bolt
(3) easily.
(8)
Install the washer (5) and the nut (6).
(9)
Tighten the nut (6).
(10) Install the cotter pin (16) (7). Subtask 53-15-11-020-056
B. Removal of the Sling-Radome.
(1)
Loosen SLING-RADOME (42) and remove it from the radome (10).
(2)
Remove the lifting equipment.
EFF : ALL
53-15-11Page 427
May 01/05
R
CES
Subtask 53-15-11-720-051
C. Functionnal Test.
(1)
Fully open the radome (10) (Ref. TASK 53-15-11-010-001).
(2)
Make sure that the radome is locked correctly:
(a)
The bush (13) is in the maximum low position.
(b)
The painted red ring is not in view.
(3)
Close the radome. (Ref. TASK 53-15-11-410-001)
5. Close-up
________
Subtask 53-15-11-010-054
A. Opening of the Radome.
(1) Fully open the radome (10) (Ref. TASK 53-15-11-010-001).
Subtask 53-15-11-865-057
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit
breaker(s): R 5SQ1, 5SQ2
Subtask 53-15-11-942-055
C. Close Access
(1)
Remove the plastic bag from the radome.
(2)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
(3)
Close the radome (Ref. TASK 53-15-11-410-001).
(4)
Remove the warning notice(s).
(5)
Remove the access platform(s).
EFF : ALL
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(104)
