曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (2) Make sure that there is no:
 (a) corrosion damage: - If you find corrosion damage, refer to the Structural Repair Manual (Ref. SRM 512200 P.Block 001) for types, inspection, removal and corrosion protection.
 (b) other damage (cracks, scratches, stress, marks, dents, bumps,...): - If you find other damage, refer to the Structural Repair Manual (Ref. SRM 511100 P.Block 001) for damage classification and corrective action.
 Subtask 53-11-00-916-065
 B. Application of the Temporary Protection
 CAUTION : DO NOT APPLY TEMPORARY PROTECTION ON THE OXYGEN SYSTEMS._______ MAKE SURE THAT THE TEMPORARY PROTECTION DOES NOT GET: -ON COMPOSITE PARTS, CONTROL CABLES, PULLEYS,TEFLON BEARINGS. -ON LUBRICATED SURFACES. -IN DRAIN VALVES OR OTHER ORIFICES. TEMPORARY PROTECTION ON OR IN THESE PARTS CAN CAUSE DAMAGE.
 (1) Apply masking paper or masking tape BONDING AND ADHESIVE COMPOUNDS (Material No. 08-074) on the equipment and fittings adjacent to the area.
 (2) Apply a layer of STORAGE PRESERVATION (Material No. 15-005) or STORAGE PRESERVATION (Material No. 15-006) to the inspection area.
 (3) Remove the masking tape or the masking paper.

 

R Internal Structure below the Forward Passenger/Crew Doors and the Cabin Floor R Level R Figure 634/TASK 53-11-00-991-045
 EFF : ALL 53-11-00Page A631 Aug 01/03
 CES  5. Close-up

________ Subtask 53-11-00-410-093
 A. Close Access
 (1)
 Install the insulation (Ref. TASK 25-80-00-400-001).

 (2)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (3)
 Close the lateral avionics-compartment doors 812 (824) (Ref. TASK 52-41-00-410-002).

 (4)
 Remove the access platform(s).

 EFF : ALL 53-11-00Page A632

Aug 01/03
R
 CES

 TASK 53-11-00-210-036
R Detailed Inspection of Fuselage Internal Structure, below Batteries, between FR R 10 and FR 16, RH
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 531167-01
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific  access platform 1.80 m (5 ft. 11 in.)
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
No specific masking paper
 Material No. 08-074
 MASKING TAPE (Ref. 20-31-00)

 Material No. 11-004  USA MIL-T-81533
 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM)
 (Ref. 20-31-00)

 Material No. 15-005  AIB TN 10138 TYPE I GRADE 2 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
 Material No. 15-006  AIB TN 10138 TYPE I GRADE 3 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
 Material No. 19-003  USA AMS 3819
 LINT-FREE COTTON CLOTH (Ref. 20-31-00)

 

 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R R R  25-80-00-000-001 25-80-00-400-001 52-41-00-010-002 52-41-00-410-002 SRM 511100 P.Block 001 SRM 512200 P.Block 001 53-11-00-991-048  Removal of the Insulation BlanketsInstallation of the Insulation Blankets Open the Avionics Compartment Doors for Access Close the Avionics Compartment Doors after Access(for corrective action)(for corrective action) Fig. 635
 3. Job Set-up__________
 Subtask 53-11-00-010-076
 A. Get Access
 (1) Put an access platform at the zone 126. 
R  (2) Open the avionics compartment door 822 (Ref. TASK 52-41-00-010-002).
 (3) Remove the insulation blankets (Ref. TASK 25-80-00-000-001).
 Subtask 53-11-00-110-084
 B. Cleaning of the Structure
 WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED. 
R R  (1) Clean the inspection area with CLEANING AGENTS (Material No. 11-004) and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003), if necessary.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(64)