(2)
Remove the shields (1), (4) and (5).
EFF : ALL
53-11-41Page 402
Upper Protective Shield
Figure 401/TASK 53-11-41-991-001
EFF : ALL 53-11-41 Page 403
Nov 01/99
CES
Lower Protective Shields
Figure 402/TASK 53-11-41-991-002
EFF : ALL 53-11-41 Page 404
Nov 01/99
CES
TASK 53-11-41-400-001 Installation of the Protective Shields - FR1 CAUTION : DO NOT USE THE LOCALIZER ANTENNA AT THE BOTTOM OF THE RADOME AS A
_______ SUPPORT.
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
the External Power 53-15-11-010-001 Opening of the Radome 110AL 53-15-11-410-001 Closing of the Radome 110AL 53-11-41-991-001 Fig. 401 53-11-41-991-002 Fig. 402
3. Job Set-up
__________ Subtask 53-11-41-860-050
A. Aircraft Maintenance Configuration
(1)
Make sure that the ground service network is energized
(Ref. TASK 24-42-00-861-001).
(2)
Make sure that access platform is in position below the radome in the zone 110.
(3)
Make sure that the radome 110AL is open (Ref. TASK 53-15-11-010-001). WARNING : DO NOT OPEN THE RADOME IF THE WIND SPEED IS MORE THAN 35
_______
KNOTS.
EFF : ALL
53-11-41Page 405
May 01/05
R
CES
R
R
R
R
Subtask 53-11-41-865-051
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
**ON A/C 051-099,
121VU COM NAV/RADAR/2 5SQ2 K14 **ON A/C ALL
4. Procedure
_________ Subtask 53-11-41-420-050
A. Installation of the Protective Shields
(Ref. Fig. 401/TASK 53-11-41-991-001, 402/TASK 53-11-41-991-002)
(1)
Put the shields (1), (4) and (5) in position.
(2)
Install the screws (3) and the washers (2).
(3)
Tighten the screws (3).
5. Close-up
________ Subtask 53-11-41-865-052
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 5SQ1, 5SQ2.
Subtask 53-11-41-410-050
B. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the radome 110AL (Ref. TASK 53-15-11-410-001).
(3)
Remove the access platform(s).
EFF : ALL
53-11-41Page 406
(4) Remove the warning notice(s). Subtask 53-11-41-862-050
C. De-energize the ground service network (Ref. TASK 24-42-00-862-001)
EFF : ALL
53-11-41Page 407
FLOOR PANELS - REPAIRS
______________________
TASK 53-12-00-300-001
Repair of the Damaged Area of the Adhesive Tape
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 3.50 m (11 ft. 6 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身1(88)
