R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,

 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 Subtask 57-52-00-110-062
 A. Preparation for Inspection
 (1) Use a clean MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the external surface of the trunnion attachment bracket.
 Subtask 57-52-00-210-055
 B. Inspection
 (1) Examine the external surface of the trunnion attachment bracket and the inboard trunnion, where it can be seen. Make sure that:
 -
there is no corrosion or damage

 -
there are no cracks

 -the protective treatment is in the correct condition.
 NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200000) for the

____
 correct repair procedure.

 5. Close-up
________ Subtask 57-52-00-410-086
 A. Close Access
 (1) Install the inboard flap seals (Ref. TASK 27-54-61-400-007). Subtask 57-52-00-865-073
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 651 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 Subtask 57-52-00-860-090

 C. Aircraft Maintenance Configuration
 (1) Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever.
 (2) Fully retract the flaps (Ref. TASK 27-50-00-866-009). Subtask 57-52-00-942-061
 D. Removal of Equipment
 (1)
 Remove the access platform(s).

 (2)
 Remove the warning notice(s).

 (3)
 Remove the safety barriers.

 (4)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 652 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 TASK 57-52-00-220-006

 Special Detailed Inspection of Inboard Flap, Trunnion Attachment Bracket including Inboard Trunnion, LH/RH
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 575203-02
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
 No specific safety barriers
 No specific warning notices
 No specific access platform 2.5 m (8 ft. 2 in.)

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 653 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 B. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground NTM 57-52-03 PART 9 ASRM 575200 (for corrective action) 57-52-00-991-010 Fig. 610
 3. Job Set-up
__________ Subtask 57-52-00-941-064
 A. Safety Precautions
 (1) Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
 (2) Put the safety barriers in position. Subtask 57-52-00-860-099
 B. Aircraft Maintenance Configuration
 (1)
 Fully extend the flaps (Ref. TASK 27-50-00-866-008).

 (2)
 Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(25)