R Subtask 57-52-00-865-093
R C. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------
R PANEL DESIGNATION IDENT. LOCATION
R -------------------------------------------------------------------------------
R 49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07
R 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
R Subtask 57-52-00-010-070
R D. Get Access
R (1) Put the access platform in position below the flap track 2 at zone
R 531(631).
R (2) Remove the applicable flap track fairings (Ref. TASK 57-55-11-000-
R 004):
R - for the left wing, remove 531AT, 531CB
R - for the right wing, remove 631AT, 631CB.
R (3) Remove the flap kink-seals (Ref. TASK 27-54-61-000-002).
R (4) Put the spark-proof lamp adjacent to the inspection area.
R 4. Procedure_________
R (Ref. Fig. 619/TASK 57-52-00-991-019)
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______
R EDGE:
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
R - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.
R INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R Subtask 57-52-00-210-061
R A. Inspection.
R (1) Do an inspection of the carriage attachment bracket. Make sure that:
R - there is no damage
R - there is no corrosion
R - there are no cracks or scores
R - the surface protection is in the correct condition
R - the attachment bolts are tight.
R Inboard Flap - Track 2 Carriage Attachment Bracket - Inspection Area R Figure 619/TASK 57-52-00-991-019
1EFF : 301-399, 1 57-52-00Page A615 1 1 May 01/04 1 1 1CES 1
R NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the____
R correct repair procedure.
R 5. Close-up________
R Subtask 57-52-00-410-072
R A. Close Access
R (1) Install the flap kink-seals (Ref. TASK 27-54-61-400-006).
R (2) Remove the spark-proof lamp from the inspection area.
R (3) Make sure that the work area is clean and clear of tool(s) and other
R items.
R (4) Install the applicable flap track fairings (Ref. TASK 57-55-11-400-
R 004):
R - for the left wing, install 531AT, 531CB
R - for the right wing, install 631AT, 631CB.
R Subtask 57-52-00-865-094
R B. Remove the safety clip(s) and the tag(s) and close this(these) circuit
R breaker(s):
R 6CV, 8CV.
R Subtask 57-52-00-860-060
R C. Aircraft Maintenance Configuration
R (1) Fully retract the flaps (Ref. TASK 27-50-00-866-009).
R Subtask 57-52-00-942-071
R D. Removal of Equipment
R (1) Remove the safety barriers.
R (2) Remove the access platform(s).
R (3) Remove the warning notice(s).
R (4) Remove the ground support and maintenance equipment, the special and
R standard tools and all other items.
R TASK 57-52-00-210-004
R Detailed Visual Inspection of Inboard Double Slotted Flap, Attachment Bracket
R of Pylon Aft Fairing, Including Surrounding Skin, LH/RH
R WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______
R START A TASK ON OR NEAR:
R - THE FLIGHT CONTROLS
R - THE FLIGHT CONTROL SURFACES
R - THE LANDING GEAR AND THE RELATED DOORS
R - COMPONENTS THAT MOVE.
R WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______
R GEAR.
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(41)
