曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  correct repair procedure. If the defect is not included in 
R  this repair, you must request a procedure from Airbus 
R  Industrie. 
R  5. Close-up________ 
R  Subtask 57-52-00-410-071 
R  A. Close Access 
R  (1) Remove the spark-proof lamp from the inspection area. 
R  (2) Use BONDING AND ADHESIVE COMPOUNDS (Material No. 08-061A), cut to the 
R  correct dimensions, to make the new covers for the inspection holes. 
R  (3) Install the new covers on the inspection holes. 
R  (4) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  (5) Install the flap track 2 fairing 531CB (631CB) and the access panel 
R  531AT (631AT) (Ref. TASK 57-55-11-400-004). 
R  (6) Install the access panel 581AB (681AB) in the bottom skin of the 
R  inboard flap. 
R  Subtask 57-52-00-865-092 
R  B. Remove the safety clip(s) and the tag(s) and close this(these) circuit 
R  breaker(s): 
R  6CV, 8CV.

 

R Subtask 57-52-00-860-058

R  C. Aircraft Maintenance Configuration 
R  (1) Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat 
R  control lever. 
R  (2) Retract the flaps (Ref. TASK 27-50-00-866-009). 
R  Subtask 57-52-00-942-070 
R  D. Removal of Equipment 
R  (1) Remove the access platform(s). 
R  (2) Remove the safety barriers. 
R  (3) Remove the warning notice(s). 
R  (4) Remove the ground support and maintenance equipment, the special and 
R  standard tools and all other items.

R TASK 57-52-00-210-003

R  Detailed Visual Inspection of Inboard Double Slotted Flap, Flap to Carriage 
R  Attachment Bracket at Track 2, LH/RH 
R  WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ 
R  START A TASK ON OR NEAR: 
R  - THE FLIGHT CONTROLS 
R  - THE FLIGHT CONTROL SURFACES 
R  - THE LANDING GEAR AND THE RELATED DOORS 
R  - COMPONENTS THAT MOVE. 
R  WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______ 
R  GEAR. 
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______ 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. 
R  - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. 
R  INCORRECT INSTALLATION CAN CAUSE DAMAGE. 
R  1. Reason for the Job__________________ 
R  Refer to the MPD TASK: 575227-01 
R  2. Job Set-up Information______________________ 
R  A. Fixtures, Tools, Test and Support Equipment 
R  -------------------------------------------------------------------------------
R  REFERENCE  QTY DESIGNATION 
R  -------------------------------------------------------------------------------
R  No specific  circuit breaker(s) safety clip(s) 
R  No specific  safety barriers 
R  No specific  spark-proof lamp 
R  No specific  warning notice 
R  No specific  access platform 2.5 m (8 ft. 2 in.)

 

R B. Referenced Information

R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R 27-50-00-866-008 R 27-50-00-866-009 R 27-54-61-000-002 R 27-54-61-400-006 R 57-55-11-000-004 R 57-55-11-400-004 R R ASRM 575200 R 57-52-00-991-019
R 3. Job Set-up
__________
R Subtask 57-52-00-941-072
R A. Safety Precautions Extension of the Flaps on the Ground Retraction of the Flaps on the Ground Removal of the Flap Kink-Seals Installation of the Flap Kink-Seals Removal of the Flap Track Fairings Nos. 2, 3 and 4 Installation of the Flap Track Fairings Nos. 2, 3 and 4 (for corrective action) Fig. 619
R (1) Put a warning notice on the flap/slat control lever (panel 114VU) to R tell persons not to operate the flaps. R (2) Put the safety barriers in position. R Subtask 57-52-00-860-059 R B. Aircraft Maintenance Configuration R WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ R CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS R AND/OR DAMAGE.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(40)