曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R (1) Put a warning notice on the flap/slat control lever (panel 114VU) to R tell persons not to operate the flaps. R (2) Put the safety barriers in position. R Subtask 57-52-00-860-055 R B. Aircraft Maintenance Configuration R WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ R CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS R AND/OR DAMAGE.
R (1) Fully extend the flaps (Ref. TASK 27-50-00-866-008).
R (2) Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is R installed on the flap/slat control lever on the panel 114VU.
R Subtask 57-52-00-865-089
R C. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------R PANEL DESIGNATION IDENT. LOCATION R -------------------------------------------------------------------------------R 49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 R 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21

R Subtask 57-52-00-010-068

R  D. Get Access 
R  (1) Put the access platform in position below the zone 531(631). 
R  (2) Remove the applicable flap track fairing (Ref. TASK 57-55-11-000-
R  004): 
R  - for the left wing, remove 531AT, 531CB 
R  - for the right wing, remove 631AT, 631CB. 
R  (3) Put the spark-proof lamp adjacent to the inspection area. 
R  4. Procedure_________ 
R  (Ref. Fig. 617/TASK 57-52-00-991-017) 
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______ 
R  EDGE: 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. 
R  - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. 
R  INCORRECT INSTALLATION CAN CAUSE DAMAGE. 
R  Subtask 57-52-00-210-060 
R  A. Inspection. 
R  (1) Do an inspection of the drive strut, drive lever and attachment 
R  brackets of the flap track 2. Make sure that: 
R  - there is no damage 
R  - there is no corrosion 
R  - there are no cracks or scores 
R  - the surface protection is in the correct condition. 
R  NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the____ 
R  correct repair procedure.

 

R Inboard Flap - Drive Strut, Drive Lever and Attachment Brackets - Inspection R Area R Figure 617/TASK 57-52-00-991-017
 1EFF : 301-399, 1 57-52-00Page A604 1 1 May 01/04 1 1 1CES 1

R  5. Close-up________ 
R  Subtask 57-52-00-410-070 
R  A. Close Access 
R  (1) Remove the spark-proof lamp from the inspection area. 
R  (2) Install the applicable flap track fairing (Ref. TASK 57-55-11-400-
R  004): 
R  - for the left wing, install 531AT, 531CB 
R  - for the right wing, install 631AT, 631CB. 
R  (3) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  Subtask 57-52-00-865-090 
R  B. Remove the safety clip(s) and the tag(s) and close this(these) circuit 
R  breaker(s): 
R  6CV, 8CV. 
R  Subtask 57-52-00-860-056 
R  C. Aircraft Maintenance Configuration 
R  (1) Fully retract the flaps (Ref. TASK 27-50-00-866-009). 
R  Subtask 57-52-00-942-069 
R  D. Removal of Equipment 
R  (1) Remove the access platform(s). 
R  (2) Remove the safety barriers. 
R  (3) Remove the warning notice(s). 
R  (4) Remove the ground support and maintenance equipment, the special and 
R  standard tools and all other items.

 

R  TASK 57-52-00-220-010 
R  Special Detailed Inspection of Inboard Double Slotted Flap, Internal Brackets 
R  at Track 2, LH/RH 
R  WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ 
R  START A TASK ON OR NEAR: 
R  - THE FLIGHT CONTROLS 
R  - THE FLIGHT CONTROL SURFACES 
R  - THE LANDING GEAR AND THE RELATED DOORS 
R  - COMPONENTS THAT MOVE. 
R  WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______ 
R  GEAR. 
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______ 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼4(38)