TO STABILIZE (|5 DEGREES) FOR A MINIMUM OF ONE HOUR.

2  FOR A PERIODIC ADJUSTMENT WITHOUT A DISCREPANCY REPORT, THE CABLE TENSION LIMITS ARE +15/-20 POUNDS (+6.8/-9.07 Kg) FROM THE VALUES IN THE TABLE I. FOR CABLE TENSION CHECKS AFTER A DISCREPANCY REPORT, THE LIMITS ARE |5 POUNDS (2.27 Kg) FROM THE VALUES IN THE TABLE. WHENEVER YOU ADJUST THE TENSION OF THE CABLE, YOU MUST GET THE VALUES IN THE TABLE.
LOCKWIRE

WSA 2
(EXAMPLE, 4 LOCATIONS)

Wing Spoiler Cables and Turnbuckles
Figure 401

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-61-61
 ALL  ú
 ú  02  Page 402
 ú  Nov 12/00 

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 024-009
 (2)  
Remove the quadrant (Fig. 402):

 (a)  
Remove the bolt that attaches the forward end of the actuator link to the actuator input arm.

 (b)  
Remove the pivot bolt from the quadrant.

 (c)  
Remove the quadrant from the structure.

 (d)  
Keep the upper bearing and the spacer in the quadrant with a bolt.

 NOTE: The lower bearing is permanently installed in the
____
 quadrant.

 TASK 27-61-61-404-010
 3. Flight Spoiler Actuator Quadrant Installation
_____________________________________________
 A. Special Tools and Equipment
 (1)  Rig Pin Kit - F70207-93:
RIG PIN NO. A/S-8, A/S-9, A/S-10 OR A/S-11
PIVOT BOLT
ACTUATOR
MOUNTING BOLT ACTUATOR LINK 
INPUT ARM ACTUATOR 
QUADRANT  LINK ACTUATOR 
FWD 
(NO. 3, 6 AND 7 EQUIVALENT) FLIGHT SPOILER ACTUATOR QUADRANT NO. 2 
Figure 402 Flight Spoiler Actuator Quadrant Installation 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-61-61
 ALL  ú ú 01 Page 403 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 B.
C.
D.
E.
A 737-300/400/500MAINTENANCE MANUAL
 ~....................................................................... | | | DIAMETER | LENGTH | | | REF NO. | F70207-( )| (INCHES) | (INCHES) | FUNCTION | .........................................................................
 | A/S-8  |  -23  | 0.246-0.248 | 3.7  |0.25 | SPOILER ACTUATOR  |
 |  |  |  |  |  QUADRANT-LEFT WING  |
 | A/S-9  |  -23  | 0.246-0.248 | 3.7  |0.25 | SPOILER ACTUATOR  |
 |  |  |  |  |  QUADRANT-LEFT WING  |
 | A/S-10  |  -23  | 0.246-0.248 | 3.7  |0.25 | SPOILER ACTUATOR  |
 |  |  |  |  |  QUADRANT-RIGHT WING |
 | A/S-11  |  -23  | 0.246-0.248 | 3.7  |0.25 | SPOILER ACTUATOR  |
 |  |  |  |  |  QUADRANT-RIGHT WING |
 | A/S-14  |  -11  | 0.309-0.311 | 6.7  |0.25 | SPOILER MIXER  |

 2.........…...........….............…............…......................1
Standard Tools and Equipment
 (1)
Cable Tensiometer - 0 to 100 pounds for 3/32-inch cableReferences

 (1)  
24-22-00/201, Manual Control

 (2)  
27-61-00/201, Spoiler Control System

 (3)  
27-61-61/501, Flight Spoiler Actuator Quadrant

 (4)
27-61-61/801, Flight Spoiler Actuator QuadrantAccess

 (1)  
Location Zone 101, 102 Control Cabin 216, 217 Main Wheel Well 307, 407 Wing Trailing Edge Outboard Flap and Spoilers

Procedure
 S 214-021
 (1)  
Examine the flight spoiler actuator quadrant for worn areas (AMM 27-61-51/601).

 S 424-011

 (2)  
Install the quadrant (Fig. 402):

 (a)  
Remove the bolt from the upper bearing and the spacer.

 (b)  
Put the quadrant in its position on the structure.

 (c)  
Install the pivot bolt, washer and nut.

 (d)  
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 5(70)