曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 ALL  ú ú 01 Page 410 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 RAM AIR EXIT DOOR ACTUATOR - REMOVAL/INSTALLATION
_________________________________________________
 1.  General_______
 A.  This procedure has two tasks. The first task is the removal of the actuator for the door at the ram air exit. The second task is the installation of the actuator for the door at the ram air exit.
 B.  The removal of the actuator has these steps:
 -Get access to the actuator
 -
Remove power from the pack control system

 -
Remove the actuator.

 C.  The installation of the actuator has these steps:
 -Install the actuator to the frame
 -Retract the actuator
 -Connect the actuator to the actuator arm
 -Do a test of the actuator.
 TASK 21-62-05-004-001
 2.  Ram Air Exit Door Actuator Removal (Fig. 401)__________________________________
 A.  References
 (1)
AMM 06-09-03/201, Body Section 44 Access Doors and Panels

 (2)
IPC 21-51-73 Fig. 1

 B.  Access
 (1)  
Location Zone
 133 Air Conditioning Equipment Bay, LH
 134 Air Conditioning Equipment Bay, RH

 (2)  
Access Panel
 191EL Air Conditioning (Pack 1)
 191ML Air Conditioning (Pack 2)
 192ER Air Conditioning (Pack 3)

 

 C.  Prepare to Remove the Actuator
 S 014-002
 (1) Open the access panel for the applicable pack (AMM 06-09-03/201):
 -191EL for the pack 1
 -191ML for the pack 2
 -192ER for the pack 3.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 21-62-05
 ALL  ú ú 01 Page 401 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

747-400
MAINTENANCE MANUAL

SEE A
RAM AIR EXIT DOOR ACTUATOR
SEE B
RAM AIR EXIT DOOR
A
Ram Air Exit Door Actuator Installation Figure 401 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 21-62-05
 ALL  ú ú 01 Page 402 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

747-400
MAINTENANCE MANUAL

9.  CONNECTOR ELECTRICAL  8. NUT  7. WASHER  1.  2. ACTUATOR (3 LOCATIONS) WASHER 
6.  BOLT  7.  8. WASHER  NUT  4. 3. NUT BOLT 
5.  JUMPER BONDING 
6. BOLT 
B 
11 INCHES (280 mm) FULLY EXTENDED 

C
Ram Air Door Actuator Installation
Figure 401 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 21-62-05
 ALL  ú ú 01 Page 403 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-024
 (2)  
Put the PACKS (1, 2 or 3) switch to OFF, on the P5 overhead panel for the applicable pack (1, 2 or 3).

 S 864-025

 (3)  
Put a DO-NOT-OPERATE tag on the PACKS switch.

 S 864-026

 (4)
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 (a)  
P6 Main Power Distribution Panel
 1) 6F35, PACK TEMP CONT A
 2) 6F36, PACK TEMP CONT B

 (b)  
P415 Power Distribution Center - Right 1) 415C38, PACK TEMP CONT B 2) 415K27, PACK TEMP CONT A

 

 D. Remove the Actuator
 S 034-027
 (1) Disconnect the electrical connector (9) from the actuator (1):
 -DV156 for the pack 1 actuator
 -DV157 for the pack 2 actuator
 -DV158 for the pack 3 actuator.
 S 034-028
 (2)  
Remove the bolt (4), washers (2), and nut (3) to disconnect the bonding jumper (5) from the actuator lug.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 空調 AIR CONDITIONING 2(176)