2.
Where computer systems are used, the number of computer terminals should be sufficient in relation to the size of the work programme to enable easy access, unless the computer system can produce paper copies. Where microfilm or microfiche readers/printers are used, a similar requirement is applicable.
3.
Maintenance tasks should be transcribed onto the work cards or worksheets and subdivided into clear stages to ensure a record of the accomplishment of the maintenance task. Of particular importance is the need to differentiate and specify, when relevant, disassembly, accomplishment of task, reassembly and testing. In the case of a lengthy maintenance task involving a succession of personnel to complete such task, it may be necessary to use supplementary work cards or worksheets to indicate what was actually accomplished by each individual person. A worksheet or work card system should refer to particular maintenance tasks.
4.
Maintenance data should be kept up to date by:
-subscribing to the applicable amendment scheme,
-checking that all amendments are being received,
Rev 0, dated 2nd March, 2010 -monitoring the amendment status of all data.
AMC M.A.402 (a) Performance of maintenance
1.
When working outside the scope of an approved maintenance organisation personnel not authorised to issue a CRS should work under the supervision of certifying personnel. They may only perform maintenance that their supervisor is authorised to release, if the supervisor personally observes the work being carried out to the extent necessary to ensure that it is being done properly and if the supervisor is readily available, in person, for consultation. In this case licensed engineers should ensure that each person maintaining an aircraft or component has had appropriate training or relevant previous experience and is capable of performing the task required, and that personnel who carry out specialised tasks such as welding shall hold relevant certificate of competency.
2.
In the case of limited pilot owner maintenance as specified in M.A.803, any person maintaining an aircraft should have had appropriate training or relevant previous experience as accepted by DGCA and be capable of performing the task required.
3.
The general maintenance and inspection standards applied to individual maintenance tasks should meet the recommended standards and practices of the organisation responsible for the type design which are normally published in the maintenance manuals. In the absence of maintenance and inspection standards published by organisation responsible for the type design maintenance personnel should refer to the relevant aircraft airworthiness standards and procedures published or used as guidance by DGCA. The maintenance standards used should contain methods, techniques and practices acceptable to DGCA for the maintenance of aircraft and its components.
4.
Independent inspections.
4.1 The manufactures instructions for continued airworthiness should be followed when determining the need for an independent inspection.
4.2 In the absence of maintenance and inspection standards published by organization responsible for the type design, maintenance tasks that involve the assembly or any disturbance of a control system that, if errors occurred, could result in a failure, malfunction, or defect endangering the safe operation of the aircraft should be considered as flight safety sensitive maintenance tasks needing an independent inspection. A control system is an aircraft system by which the flight path, attitude, or propulsive force of the aircraft is changed, including the flight, engine and propeller controls, the related system controls and the associated operating mechanisms.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS CAR -M(50)
