曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

power-up.
Recycle power.
808 "Calibration memory lost" Calibration data lost
during power-up.
Contact CI service department at
support@calinst.com to obtain
instructions on restoring calibration data
or recalibrate unit.
813 "Missing list parameter" One or more transient list
parameters missing.
Check programmed lists.
814 "Voltage peak error " Peak voltage exceeds
internal bus voltage
This error may occur when selecting user
defined wave shapes with higher crest
factors. Reduce programmed RMS
value.
815 "Slew time exceed dwell" Time needed to slew to
final value is less than
dwell time.
Check dwell times in transient list
settings. Increase dwell time or change
slew rate for affected parameter.
816 "Illegal during transient" Operation requested not
available while transient is
running.
Wait till transient execution is completed
or abort transient execution first.
817 "Output relay must be
closed"
Transient programmed
with output relay open.
Close relay before attempting transient
operation.
819 "Clock and sync must be
internal"
Operation not possible
with external clock
Switch to internal sync. (Default)
820 "Input buffer full" Too much data received. Break up data in smaller blocks.
821 "PFC Input Fault " AC input line related error. Possibly due to low line input condition
requiring too much input current.
822 "Waveform harmonics
limit"
Harmonic contents of user
defined wave shape is too
high and could damage
amplifier output stage.
Reduce harmonic content or reduce
fundamental frequency programmed.
823 "Amplifier fault" An amplifier failure. Can
be reported at any time.
Determine which amplifier is at fault with
self-test or checking LED on Relay
Board. Replace amplifier.
824 “Auxiliary down” One or more auxiliary
units is not powered up or
not working.
Turn on all auxiliary units.
California Instruments 150
User Manual Compact i/iX Series
California Instruments 151
Number Message String Cause Remedy
825 “Over voltage prot trip” Over voltage detected on
output
Check output voltage for correct RMS
value.
826 “Peak current prot trip” Peak current limit
exceeded.
Peak current exceeded. Could be caused
by switching EUT on or off.
827 “Frequency error” Frequency error during
self-test.
Correct frequency was not measured
during self-test. May be result of 801
error.
828 “Phase error” Self test error phase angle Correct phase angle was not measured
during self-test. May be result of 801
error.
829 “Dc component exceed
limit”
Too much DC content in
loaded ARB waveform.
Check waveform programming.
Table 15-1: Error Messages
User Manual Compact i/iX Series
California Instruments 152
16. Index
160................................................................... 26
704................................................................... 26
ABD.................................................................. 26
ABL .......................................................... 26, 108
ABLE................................................................ 70
ATLAS ......................................................... 26
Acoustic Noise................................................... 22
address
GPIB............................................................ 69
IEEE ............................................................ 69
Airbus
DO160 ....................................................... 114
ALC
state............................................................. 61
AMD................................................................. 26
Option........................................................ 144
Arbitrary waveforms
Frequency response restrictions................. 81
arrow keys....................................................... 50
B787................................................................. 26
Back key.......................................................... 51
baud rate......................................................... 69
blinking
parameter entry ........................................... 50
bus address
setting .......................................................... 69
calibration
password ..................................................... 94
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：航空資料11(164)