曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R 
R  TUNING TO GES  This status is shown after the selected satellite has 
R  been proven acceptable and while the AES tunes to the 
R  selected GES. 
R 
R  SPOT BEAM SEARCH  This status is shown while the SDU is determining the 
R  optimal spot beam for use during log-on. 
R 
R  SPOT BEAM NOT AVAIL This status is shown if the GES does not support spot 
R  beam operation either because it is not transmitting 
R  a spot beam map or the GES capabilities broadcast SU 
R  indicates that the GES does not support spot beam voice 
R  operation. 
R 
R  GES NOT AVAIL  This status is shown if the AES is in User-Commanded 
R  mode and the user selected GES is not referenced in 
R  the GES Data Table. 
R 
R  SAT NOT AVAIL  This status is shown if the AES is in User-Commanded 
R  mode and the user selected Satellite cannot be

 1EFF : 401-499, 1 23-28-00Page 24 1 1 Aug 01/05 1 1 1CES 1R (a) Available user actions for the log-on process are displayed R adjacent to line key 6R

R  received. 
R 
R  UPDATING TABLE  This status is shown while the AES is updating system 
R  tables. 
R 
R  REQUESTING LOG-ON  This status is shown after the AES has selected a GES 
R  and sent a log-on request. The AES is waiting for a 
R  Log-on Confirm (plus any optional P/R/T-channel Control 
R  SUs) from the GES. 
R 
R  WAITING ACK  This status is shown after the AES has received the 
R  Log-on Confirm (plus any optional P/R/T-channel Control 
R  SUs), and has sent a Log-on Acknowledge to the GES. The 
R  AES is waiting for a Log-on Acknowledge from the GES. 
R 
R  LOGGED ON  This status is shown after the AES has successfully 
R  logged onto a GES. While in the LOGGED ON state, the 
R  LOG -OFF* action is available. 
R 
R  LOGGING OFF  This status is shown after the AES has begun the 
R  log-off process and before going to the WAIT USER 
R  INPUT state. 
R 
R  REJECT-TEMPORARY  These statuses are shown to indicate the cause of a 
R  REJECT-PERMANENT  rejected log-on attempt. If the attempt was to a 
R  REJECT-INV PARAM  manually selected GES, the AES goes to the WAIT USER 
R  INPUT state and continually displays the cause. If 
R  the attempt was to an automatically selected GES, and 
R  the type of reject is permanent, the log-on process 
R  continues with the next selected GES and the Failed GES 
R  will not be attempted again for 1 hour. If the reject 
R  type was temporary or invalid Parameters, the GES may 
R  be tried again on ensuing log-on attempts. 
R 
R  LOG-ON FAILED  This status is shown if log-on to a user selected 
R  Satellite/GES has failed and there is no cause code 
R  available for display. (e.g. failure is due to signal 
R  loss). 
R 
R  INVALID CLASS  This status is shown if current conditions do not 
R  allow any log-on class to be utilized. 

 1EFF : 401-499, 1 23-28-00Page 25 1 1 Aug 01/05 1 1 1CES 1 1EFF : 401-499, 1 23-28-00Page 26 1 1 Aug 01/05 1 1 1CES 1 1EFF : 401-499, 1 23-28-00Page 27 1 1 Aug 01/05 1 1 1CES 1 1EFF : 401-499, 1 23-28-00Page 28 1 1 Aug 01/05 1 1 1CES 1

R  ABORT*  This action is displayed adjacent to line key 6R during 
R  the search portions of log-on. This action is displayed 
R  using the ACTION color type. Selection of line key 6R while 
R  ABORT* is displayed results in the AES aborting the search. 
R  The AES goes to the WAIT USER INPUT state. 
R 
R  LOG-OFF*  This action is possible from the REQUESTING LOG-ON 
R  WAITING ACK OR LOGGED ON state and is displayed 
R  adjacent to line key 6R. This action is displayed using the 
R  ACTION color type. Selection of line key 6R while LOG-OFF* 
R  is displayed causes the AES to go to the WAIT 
R  USER INPUT state. If the AES is in the LOGGED ON 
R  state at time of selection, the AES performs a 
R  log-off to the GES. 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM Communications 通訊1(131)