On the MCDU,
-
The second SYSTEM REPORT/TEST/COM page comes into view.
-
The SATCOM menu page comes into view.
-
The SATCOM/TEST page comes into view.
-
The SATCOM/INSTALLATION TEST pagecomes into view.
-
The TEST IN PROGRESS indication comesinto view.
-After some seconds, the TEST OK indication comes into view.
1EFF : 401-499, 1 23-28-00Page 502 1 1 Aug 01/05 1 1 1CES 1
5. Close-up
________ Subtask 23-28-00-860-063
A. Put the Aircraft back to its initial configuration.
(1)
On the MCDU, push the line key adjacent to the RETURN indication until the SATCOM MENU page comes into view.
(2)
Fully decrease the brightness of the MCDU screen (display off).
(3)
De-energize the aircraft electrical circuits
(Ref. TASK 24-41-00-862-002).
1EFF : 401-499, 1 23-28-00Page 503 1 1 Aug 01/05 1 1 1CES 1
ANTENNA - TOP - REMOVAL/INSTALLATION
____________________________________ TASK 23-28-13-000-001 Removal of the Antenna 116RV1
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps No specific circuit breaker(s) safety clip(s) No specific masking tape No specific nonmetallic scraper No specific access platform 6.0 m (19 ft. 8 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
23-28-13-991-001 Fig. 401
3. Job Set-up
__________ Subtask 23-28-13-865-050
A. Open, safety and tag this(these) circuit breaker(s): -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
C/B NOT APPLICABLE Subtask 23-28-13-941-050
B. Put the access platform in position at Zone 230.
1EFF : 401-499, 1 23-28-13Page 401 1 1 Aug 01/05 1 1 1CES 1
4. Procedure
_________ Subtask 23-28-13-020-050
A. Removal of the Antenna
(Ref. Fig. 401/TASK 23-28-13-991-001)
WARNING : BE CAREFUL WHEN YOU REMOVE OR INSTALL THE ANTENNA. THE ANTENNA
_______ WEIGHS APPROXIMATELY 12 KG (26 LBS). IF YOU DO NOT HOLD IT CORRECTLY, IT CAN FALL AND CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(1)
Remove the sealant from the screw heads with a nonmetallic scraper.
(2)
Remove the screws (1) from the antenna (2).
(3)
Lift the antenna (2) until you can see the electrical connector (3) and the coaxial connectors (6).
WARNING : CUT, REMOVE AND DISCARD THE LOCKWIRE AS YOU DO THE TASK.
_______
LOOSE LOCKWIRE CAN CUT OR BLIND YOU.
(4)
Remove and discard the lockwire from the coaxial connectors (6).
(5)
Disconnect the electrical connector (3) from the antenna and the coaxial connectors (6).
(6)
Remove the teflon gasket (if installed).
(7)
Apply masking tape around the electrical connectors (3) and attach them to the fuselage.
(8)
Put blanking caps on the disconnected electrical connectors.
(9)
Remove the antenna (2).
1EFF : 401-499, 1 23-28-13Page 402 1 1 Aug 01/05 1 1 1CES 1
Antenna
Figure 401/TASK 23-28-13-991-001
1EFF : 401-499, 1 23-28-13 Page 403
1 1 Aug 01/05
1 1
1CES 1
TASK 23-28-13-400-001
Installation of the Antenna 116RV1
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______ ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
WARNING : DO NOT GET THE COMPOUND ON YOUR SKIN.
_______ IF YOU DO:
-RUB IT OFF IMMEDIATELY WITH A CLEAN CLOTH
-WASH THE SKIN WITH SOAP AND RINSE WITH CLEAN WATER.
WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM Communications 通訊1(141)
