曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (g) TEST 
R  (Ref. Fig. 029, 030) 
R  The TEST page permits the detection and the isolation of faulty 
R  equipment. 
R  (h) GROUND REPORT 
R  (Ref. Fig. 031) 
R  This function permits the display of all the class 1, 2 and 3 
R  internal faults.

 1EFF : 401-499, 1 23-28-00Page 45 1 1 Aug 01/05 1 1 1CES 1

R  SATCOM - PREVIOUS LEGS REPORT 
R  Figure 024
 1EFF :  401-499,  1  23-28-00 Page 46 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - LRU IDENTIFICATION 
R  Figure 025
 1EFF :  401-499,  1  23-28-00 Page 47 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - GROUND SCANNING 
R  Figure 026
 1EFF :  401-499,  1  23-28-00 Page 48 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - TROUBLE SHOOTING DATA 
R  Figure 027
 1EFF :  401-499,  1  23-28-00 Page 49 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - CLASS 3 FAULTS 
R  Figure 028
 1EFF :  401-499,  1  23-28-00 Page 50 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - TEST 1/2 
R  Figure 029
 1EFF :  401-499,  1  23-28-00 Page 51 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - TEST 2/2 
R  Figure 030
 1EFF :  401-499,  1  23-28-00 Page 52 
1  1  Aug 01/05
 1  1
 1CES  1

 

R  SATCOM - GROUND REPORT 
R  Figure 031
 1EFF :  401-499,  1  23-28-00 Page 53 
1  1  Aug 01/05
 1  1
 1CES  1

 

 SATELLITE COMMUNICATION - MAINTENANCE PRACTICES
_______________________________________________ TASK 23-28-00-860-001 Procedure after a Change of Aircraft Registration Number
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AWM 23-28-11
 3. Job Set-up
__________ Subtask 23-28-00-865-069
 A. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
C/B NOT APPLICABLE
 4. Procedure
_________ Subtask 23-28-00-860-072
 A. Procedure to change the ICAO address
 (1) Take the ICAO address and convert it into binary format
 (a)
 Find the plug to be pin-programmed (Ref. AWM 23-28-11)

 (b)
 Connect the pin-programming according to the binary format of the ICAO address. Any pin to be coded "0" on the plug, must be connected to the common pin 25 of the same plug.

 1EFF : 401-499, 1 23-28-00Page 201 1 1 Aug 01/05 1 1 1CES 1

 NOTE : Pin 1 of the plug is MSB
____
 NOTE : For example, ICAO address 76CD46 (hexadecimal)/35546506
____ (octal) must be converted into 0111 0110 1100 1101 0100 0110 (binary). Thus, pins 1, 5, 8, 11, 12, 15, 17, 19, 20, 21, and 24 of the plug must be connected to pin 25 (Ref. AWM 23-28-11).
 Subtask 23-28-00-865-070
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): C/B NOT APPLICABLE
 1EFF : 401-499, 1 23-28-00Page 202 1 1 Aug 01/05 1 1 1CES 1 SATELLITE COMMUNICATION - SERVICING

___________________________________
 TASK 23-28-00-600-002
 Uploading of the USER ORT part of the SATCOM software with the Multipurpose
 Disk Drive Unit (MDDU)
 1.
 Reason for the Job

__________________
 Upload the USER ORT part of the SATCOM software with the MDDU.

 2.
 Job Set-up Information

______________________
 A. Referenced Information
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM Communications 通訊1(138)