C. Expendable Parts
-------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
1 O-ring 24-21-51 02 -180 1 O-ring 24-21-51 02A-180
R 1 O-ring 24-21-51 02D-200 2 filter element 24-21-51 02 -170 2 filter element 24-21-51 02 -170A 2 filter element 24-21-51 02A-170
R 2 filter element 24-21-51 02D-210 3 O-ring 24-21-51 02 -160 3 O-ring 24-21-51 02A-160
R 3 O-ring 24-21-51 02D-220 6 O-ring 24-21-51 02 -020
-------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
R 6 6 O-ring O-ring 24-21-51 02A-020 24-21-51 02D-020
D. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-32-24-281-001 24-21-00-210-044 24-21-00-612-043 24-42-00-861-001 24-42-00-862-001 71-00-00-710-001 71-00-00-710-003 71-00-00-710-006 71-13-00-010-040 71-13-00-410-040 78-30-00-081-041 78-30-00-481-041 Sampling of the IDG Oil for AnalysisInspection of the Filter Element(s)Servicing of the IDG after Oil Chemical ContaminationEnergize the Ground Service Network from the External PowerDe-energize the Ground Service Network Supplied from the External PowerDry Motoring CheckEngine Automatic StartMinimum Idle CheckOpening of the Fan Cowl DoorsClosing of the Fan Cowl DoorsMake the Thrust Reverser Serviceable after MaintenanceMake the Thrust Reverser Unserviceable for Maintenance
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
24-21-00-991-301 Fig. 301
R **ON A/C 401-499,
R 24-21-00-991-301-A Fig. 301A
R **ON A/C ALL
3. Job Set-up
__________
Subtask 24-21-00-861-053
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
Subtask 24-21-00-941-066
B. Safety Precautions
(1)
On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice in position to tell persons not to start the engine.
(2)
Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3)
On the overhead maintenance panel 50VU:
(a)
Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b)
Put a warning notice in position to tell persons not to energize the FADEC 1(2).
Subtask 24-21-00-010-072
C. Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
-
FOR 1000EM1
437AL, 438AR
-
FOR 1000EM2
447AL, 448AR
Subtask 24-21-00-481-051
D. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041).
4. Procedure_________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
(Ref. Fig. 301/TASK 24-21-00-991-301)
R **ON A/C 401-499,
R (Ref. Fig. 301A/TASK 24-21-00-991-301-A)
R **ON A/C ALL
Subtask 24-21-00-864-056
A. Depressurization of the IDG Case
WARNING : POINT THE OVERFLOW DRAIN HOSE INTO A CONTAINER WHEN YOU CONNECT_______ THE HOSE TO THE OVERFLOW DRAIN VALVE. THIS WILL PREVENT BURNS FROM THE HOT OIL SPRAY. HOT OIL CAN CAUSE BURNS TO EYES AND SKIN.
CAUTION : DO NOT USE DEVICES OTHER THAN THE APPROVED OVERFLOW DRAIN-HOSE_______ FITTING. HARD METAL OBJECTS SUCH AS SCREWDRIVERS CAN CAUSE DAMAGE TO THE OVERFLOW DRAIN-VALVE SEAT.
(1) Put a container 5.7 l (1.5 USgal) (11) below the IDG (15).
(2) Remove the dust cap (10) from the overflow drain valve (13).
(3) Put the end of the overflow drain hose (12) of the TANK - ENGINE OIL FILLING UP (DH13PM) in the container (11).
(4) Do this step to depressurize the IDG case:
(a) Connect the overflow drain hose (12) of the TANK - ENGINE OIL FILLING UP (DH13PM) to the overflow drain valve (13).
NOTE : Some oil can come out of the overflow drain hose (12) of____ the TANK - ENGINE OIL FILLING UP (DH13PM) when you connect it.
中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM ELECTRICAL POWER 電源1(48)
