R 2. Job Set-up Information
______________________
R A. Referenced Information
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R AMM 34-41-00-740-002 R AMM 34-41-12-000-001 R AMM 34-41-12-400-001 R AMM 34-41-33-000-004 R AMM 34-41-33-400-003 R R AMM 34-41-37-000-001 R R AMM 34-41-37-400-001 R R ASM 34-41/01
R 3. Fault Confirmation
__________________
R A. Test
BITE Test of the Weather Radar
Removal of the Weather Radar Control Unit (3SQ)
Installation of the Weather Radar Control Unit (3SQ)
Removal of the Weather Radar Transceiver (1SQ1, 1SQ2)
Installation of the Weather Radar Transceiver (1SQ1,
1SQ2)
Removal of the Weather Radar Transceiver Mounting
Tray (9SQ)
Installation of the Weather Radar Transceiver
Mounting Tray (9SQ)
R (1) Do the BITE test of the weather radar (Ref. AMM TASK 34-41-00-740-R 002).
R 4. Fault Isolation
_______________
R A. If the BITE test gives the maintenance message WXR MOUNTING TRAY (9SQ):
R - remove the XCVR-WEATHER RADAR, 2 (1SQ2) (Ref. AMM TASK 34-41-33-000-R 004)
R - get access to the MTG TRAY-WR XCVR (9SQ) (Ref. AMM TASK 34-41-37-000-R 001)
R - disconnect the electrical connector of the wave guide switch
R - do a check of the wiring between the WR transceiver 2 and the wave
R guide switch: pins AB/8D and A/D(Ref. ASM 34-41/01).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 051-099, ∞∞34-41-00∞∞∞∞∞∞∞∞∞∞Page 241
May 01/05 CES
R (1) If there is no continuity:
R - repair the above wiring.
R - connect the electrical connector of the wave guide switch (Ref. AMM
R TASK 34-41-37-400-001)
R - install the weather radar transceiver 2 (Ref. AMM TASK 34-41-33-
R 400-003).
R (2) If there is continuity:
R - do a check of the wiring of the weather radar transceiver mounting
R tray (9SQ):
R . from pin A/B to the ground point
R . from pin A/E to the weather radar control unit (3SQ), pins A/E
R and B/E
R (Ref. ASM 34-41/01).
R (a) If the wiring is not ok:
R - repair the above wiring.
R (b) If the wiring is ok:
R - replace the wave guide switch (Ref. AMM TASK 34-41-37-000-001)
R and (Ref. AMM TASK 34-41-37-400-001).
R 1 If the fault continues:_
R - replace the CTL UNIT-WEATHER RADAR (3SQ) (Ref. AMM TASK 34-
R 41-12-000-001) and (Ref. AMM TASK 34-41-12-400-001).
R a If the fault continues:_
R - replace the weather radar transceiver 2 (Ref. AMM TASK
R 34-41-33-000-004) and (Ref. AMM TASK 34-41-33-400-003).
R B. Do the test given in Para. 3.
R **ON A/C ALL
TASK 34-41-00-810-820
Loss of the Control Data Input 1 Bus of the Weather Radar Transceiver 1
1. Possible Causes
_______________
- XCVR-WEATHER RADAR, 1 (1SQ1)
- wiring of the CP DATA INPUT 1 bus between the weather radar transceiver 1 (1SQ1 and the first terminal block
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 34-41-00-740-002 BITE Test of the Weather Radar
AMM 34-41-33-000-004 Removal of the Weather Radar Transceiver (1SQ1, 1SQ2)
AMM 34-41-33-400-003 Installation of the Weather Radar Transceiver (1SQ1,
1SQ2)
ASM 34-41/01
3. Fault Confirmation
__________________
A. Test
(1) Do the BITE test of the weather radar (Ref. AMM TASK 34-41-00-740-002).
4. Fault Isolation
_______________
R **ON A/C 001-049, 101-105, 151-199,
A. If the BITE test gives the maintenance message FCU (2CA) BUS CP-L/WXR1 (1SQ1):
- replace the XCVR-WEATHER RADAR, 1 (1SQ1) (Ref. AMM TASK 34-41-33-000-004) and (Ref. AMM TASK 34-41-33-400-003).
(1) If the fault continues:
- remove the weather radar transceiver 1
- do a check and repair the wiring of the CP DATA INPUT 1 bus between the weather radar transceiver 1 (1SQ1 and the first terminal block : for pins AB/3B, 4B of the weather radar transceiver 1 (Ref. ASM 34-41/01). 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 3(15)
