- XCVR-WEATHER RADAR, 2 (1SQ2)
- wiring from the radio altimeter transceiver 1 to the weather radar
transceiver 2
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 34-41-00-740-002 BITE Test of the Weather Radar
AMM 34-41-33-000-004 Removal of the Weather Radar Transceiver (1SQ1, 1SQ2)
AMM 34-41-33-400-003 Installation of the Weather Radar Transceiver (1SQ1,
1SQ2) AMM 34-42-33-000-001 Removal of the Radio Altimeter Transceiver 2SA1 and 2SA2 AMM 34-42-33-400-001 Installation of the Radio Altimeter Transceiver 2SA1 and 2SA2 ASM 34-41/02
3. Fault Confirmation
__________________
A. Test Do the BITE test of the weather radar (Ref. AMM TASK 34-41-00-740-002).
4. Fault Isolation
_______________
A. If the test gives the maintenance message RA1(2SA1)/WXR2(1SQ2):
- swap the XCVR-RA, 1 (2SA1) and the radio altimeter transceiver 2 (Ref. AMM TASK 34-42-33-000-001) and (Ref. AMM TASK 34-42-33-400-001).
(1) If the fault stops:
- replace the radio altimeter transceiver that you installed on side
2.
(2) If the fault continues:
- replace the XCVR-WEATHER RADAR, 2 (1SQ2) (Ref. AMM TASK 34-41-33-000-004) and (Ref. AMM TASK 34-41-33-400-003).
(a) If the fault continues:
- remove the weather radar transceiver 2
- remove the radio altimeter transceiver 1
- do a check and repair the wiring from the radio altimeter transceiver 1 to the weather radar transceiver 2: from pins AB/2G, 3G to pins AB/1C, 2C (Ref. ASM 34-41/02)
- install the weather radar transceiver 2
- install the radio altimeter transceiver 1.
B. Do the test given in para. 3.
Loss of the Interface between the Weather Radar Transceiver 2 and the Radio Altimeter Transceiver 2
1. Possible Causes
_______________
- XCVR-RA, 2 (2SA2)
- XCVR-WEATHER RADAR, 2 (1SQ2)
- wiring from the radio altimeter transceiver 2 to the weather radar
transceiver 2
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 34-41-00-740-002 BITE Test of the Weather Radar
AMM 34-41-33-000-004 Removal of the Weather Radar Transceiver (1SQ1, 1SQ2)
AMM 34-41-33-400-003 Installation of the Weather Radar Transceiver (1SQ1,
1SQ2) AMM 34-42-33-000-001 Removal of the Radio Altimeter Transceiver 2SA1 and 2SA2 AMM 34-42-33-400-001 Installation of the Radio Altimeter Transceiver 2SA1 and 2SA2 ASM 34-41/02
3. Fault Confirmation
__________________
A. Test Do the BITE test of the weather radar (Ref. AMM TASK 34-41-00-740-002).
4. Fault Isolation
_______________
A. If the test gives the maintenance message RA2(2SA2)/WXR2(1SQ2):
- swap the XCVR-RA, 2 (2SA2) and the radio altimeter transceiver 1 (Ref. AMM TASK 34-42-33-000-001) and (Ref. AMM TASK 34-42-33-400-001).
(1) If the fault stops:
- replace the radio altimeter transceiver that you installed on side
1.
(2) If the fault continues:
- replace the XCVR-WEATHER RADAR, 2 (1SQ2) (Ref. AMM TASK 34-41-33-000-004) and (Ref. AMM TASK 34-41-33-400-003).
(a) If the fault continues:
- remove the weather radar transceiver 2
- remove the radio altimeter transceiver 2
- do a check and repair the wiring from the radio altimeter transceiver 2 to the weather radar transceiver 2 : from pins AB/2G, 3G to pins AB/5A, 6A (Ref. ASM 34-41/02)
- install the weather radar transceiver 2
- install the radio altimeter transceiver 2.
B. Do the test given in para. 3.
R
TASK 34-42-00-810-839
Loss of the Interface between Radio Altimeter Antennas and Transceiver 1
1. Possible Causes
_______________
- XCVR-RA, 1 (2SA1)
- ANTENNA-RA RCPTN, 1 (5SA1)
- ANTENNA-RA XMSN, 1 (6SA1)
2. Job Set-up Information
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 3(48)
