- replace the CMPTR-TCAS (1SG) (Ref. AMM TASK 34-43-34-000-001) and (Ref. AMM TASK 34-43-34-400-001)
- if the fault continues, do a check and repair the suppressor coaxial cable from the TCAS computer (1SG) pin AC/12 to the connector 150VC (Ref. AWM 34-43-05).
(2) If the test is OK, do the BITE test of the TCAS (Ref. AMM TASK 34-43-00-740-001):
- if the test is OK, do a check and repair the suppressor coaxial cable from the ATC transponder 2 (1SH2) pin AC/12 to the connector 150VC (Ref. AWM 34-52-03).
R **ON A/C 051-099, 106-149, 201-299, 301-399, 401-499,
R A. If the ATC2 test gives the maintenance message TCAS(1SG)/ ATC2(1SH2), and
R if the TCAS test gives the maintenance message TCAS (1SG):
R - on the center pedestal, on the ATC/TCAS control unit, set the ATC1 to
R on and do the BITE test of the ATC (system 1) (Ref. AMM TASK 34-52-00-R 740-004).
R (1) If the test gives the maintenance message TCAS(1SG)/ ATC2(1SH2):
R - replace the CMPTR-TCAS (1SG) (Ref. AMM TASK 34-43-34-000-001) and
R (Ref. AMM TASK 34-43-34-400-001)
R - if the fault continues, do a check and repair the suppressor
R coaxial cable from the TCAS computer (1SG) pin AC/12 to the
R connector 150VC (Ref. AWM 34-43-05).
R (2) If the test is OK, do the BITE test of the TCAS (Ref. AMM TASK 34-43-R 00-740-001):
R - if the test is OK, do a check and repair the suppressor coaxial
R cable from the ATC transponder 2 (1SH2) pin AC/12 to the connector
R 150VC (Ref. AWM 34-52-03).
R **ON A/C ALL
B. Do the test given in para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-43-00∞∞∞∞∞∞∞∞∞∞Page 253
Aug 01/05 CES
R
TASK 34-43-00-810-831
Incorrect Location of the TCAS Intruders on the NDs
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 34-43-00-720-001 Functional Test of the TCAS Antennas
AMM 34-43-11-000-001 Removal of the TCAS Antenna (7SG1, 7SG2)
AMM 34-43-11-400-001 Installation of the TCAS Antenna (7SG1, 7SG2)
3. Fault Confirmation
__________________
A. Test
(1) Do the functional test of the TCAS antennas (Ref. AMM TASK 34-43-00-720-001).
4. Fault Isolation
_______________
A. If the test of one TCAS antenna shows that the location of the TCAS intruders on the NDs is incorrect:
- do a check of the connectors of this antenna for moisture.
(1) If there is moisture:
- dry and clean the connectors.
(2) If there is no moisture (if the connectors are clean and in the correct condition):
(a) Make sure that:
- the connectors are in the correct position
- the antenna is in the correct position (Ref. AMM TASK 34-43-11-400-001). Repair if necessary.
(b) Do a check and repair the coaxial cables.
(3) If the fault continues:
- replace the TCAS antenna (Ref. AMM TASK 34-43-11-000-001) and (Ref. AMM TASK 34-43-11-400-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-43-00∞∞∞∞∞∞∞∞∞∞Page 254
Aug 01/05 CES
B. Do the test given in Para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-43-00∞∞∞∞∞∞∞∞∞∞Page 255
Aug 01/05R
CES Loss of the Radio Altimeter Data to the TCAS Computer
1. Possible Causes
_______________
- CMPTR-TCAS (1SG)
- ANTENNA-RA RCPTN, 1 (5SA1)
- ANTENNA-RA XMSN, 1 (6SA1)
- ANTENNA-RA RCPTN, 2 (5SA2)
- ANTENNA-RA XMSN, 2 (6SA2)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 3(65)
