- install the FWC-1
- remove the FWC-2 (1WW2) (Ref. AMM TASK 31-53-34-000-001)
1 If there is no ground signal:
_ - install a new FWC-2 (Ref. AMM TASK 31-53-34-400-001).
2 If there is a ground signal:
_
- install the FWC-2
- remove the XCVR-WEATHER RADAR, 1 (1SQ1) (Ref. AMM TASK 34-41-33-000-004)
a If there is no ground signal:
_
- install a new XCVR-WEATHER RADAR, 1 (Ref. AMM TASK 34-41-33-400-003).
b If there is a ground signal:
_
- install the XCVR-WEATHER RADAR, 1
- do a check and repair the wiring between the GPWC and the FWC 1 and FWC 2, the wiring between the GPWC and the weather radar transceiver or the wiring between the GPWC and the TCAS computer: pin AB/5D of the GPWC, pins AB/2H of the FWC 1 and FWC 2, pin AB/1D of the weather radar transceiver and pin AF/5B of the TCAS computer. (Ref. ASM 34-48/01)
**ON A/C 051-099,
A. If the test gives the maintenance message R GPWC (1WZ)/FWC1/2 (1WW1/2)/WXR1 (1SQ1):
- do a check for a ground signal at pin AB/5D of the GPWC (Ref. ASM 34-48/01).
(1) If there is no ground signal:
- replace the GPWC (1WZ) (Ref. AMM TASK 34-48-34-000-001) and (Ref. AMM TASK 34-48-34-400-001)
R (2) If there is a ground signal:
R - remove the FWC-1 (1WW1) (Ref. AMM TASK 31-53-34-000-001)
R (a) If there is no ground signal:
R - install a new FWC 1 (Ref. AMM TASK 31-53-34-400-001)
R (b) If there is a ground signal:
R - install the FWC-1
R - remove the FWC-2 (1WW2) (Ref. AMM TASK 31-53-34-000-001)
R 1_ If there is no ground signal:
R - install a new FWC-2 (Ref. AMM TASK 31-53-34-400-001).
R 2_ If there is a ground signal:
R - install the FWC-2
R - remove the XCVR-WEATHER RADAR, 1 (1SQ1) (Ref. AMM TASK 34-
R 41-33-000-004)
R a_ If there is no ground signal:
R - install a new XCVR-WEATHER RADAR, 1 (Ref. AMM TASK 34-41-
R 33-400-003).
R b_ If there is a ground signal:
R - install the XCVR-WEATHER RADAR, 1
R - remove the XCVR-WEATHER RADAR, 2 (1SQ2) (Ref. AMM TASK
R 34-41-33-000-004)
R - If there is no ground:
R install a new XCVR-WEATHER RADAR, 2 (Ref. AMM TASK 34-41-
R 33-400-003).
R - If there is a ground signal:
R do a check and repair the wiring between the GPWC and the
R FWC 1 and FWC 2, the wiring between the GPWC and the
R weather radar transceiver 1 and 2 or the wiring between
R the GPWC and the TCAS computer: pin AB/5D of the GPWC,
R pins AB/2H of the FWC 1 and FWC 2, pin AB/1D of the
R weather radar transceivers and pin AF/5B of the TCAS
R computer. (Ref. ASM 34-48/01)
R **ON A/C ALL
B. Do the test given in Para. 3.
Permanent Display of Terrain Data on CAPT ND
1. Possible Causes
_______________
- GPWC (1WZ)
- P/BSW-TERR ON ND, CAPT (30WZ1)
- wiring of the TERRAIN POP-UP CAPT discrete between the GPWC (1WZ) and the TERR ON ND, CAPT pushbutton switch (30WZ1)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 33-10-00-000-002 Removal of the Bulbs and the Body of a Pushbutton Switch in the Cockpit AMM 33-10-00-400-002 Installation of the Bulbs and the Body of a
Pushbutton Switch in the Cockpit AMM 34-48-00-740-002 BITE Test of the Enhanced GPWC AMM 34-48-34-000-001 Removal of the GPWC (1WZ) AMM 34-48-34-400-001 Installation of the GPWC (1WZ) ASM 34-48/02
3. Fault Confirmation
__________________
A. Test
(1) Do the BITE test of the Enhanced GPWS (Ref. AMM TASK 34-48-00-740-002).
4. Fault Isolation
_______________
A. If the BITE test gives the maintenance message: CAPT TERR ON ND PB SW (30WZ1)/GPWC (1WZ) - on the TERR ON ND PNL (403VU), make sure that the TERR ON ND, CAPT
pushbutton switch (30WZ1) is not pushed (the ON legend is off)
- do a check for ground at pin AA/1A of the GPWC (Ref. ASM 34-48/02).
(1) If there is no ground:
- replace the GPWC (1WZ) (Ref. AMM TASK 34-48-34-000-001) and (Ref. AMM TASK 34-48-34-400-001).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 3(85)
