曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 0.62 inch (21.0 degrees).On 65-49970-25 and subsequent stabilizer trim actuators, and 65C34751 actuators (65-49970-13 thru -24 actuators with SB 27-1161), Do a check of brake slippage: 1) Apply 1650 pound-inches torque to the upstop of the
 jackscrew in both clockwise and counter-clockwise
 directions. 2) Make sure that no slippage of the auxiliary brake occurs. 3) If slippage occurs in either direction, adjust the
 auxiliary brake by doing the following: a) Remove the lockwire from the lower stop and the umbrella assembly (Fig. 505). b) Remove the fasteners from the lower stop, the umbrella assembly, and the cover plate.
 c)  Lift the lower stop, the cap, the packing, the umbrella, and the auxiliary brake cover up the jackscrew. Use lockwire to hold parts out of the way to allow access to the auxiliary brake assembly.
 CAUTION: MAKE SURE YOU PROTECT THE PACKING FROM DAMAGE WHILE
_______ SLIDING IT UP THE JACKSCREW THREADS. TEFLON TAPE OR A PLASTIC SLEEVE CAN BE PLACED OVER THE THREADS TO PROTECT THE PACKING FROM DAMAGE. IF THE PACKING IS DAMAGED, MOISTURE CAN ENTER THE BALLSCREW ACTUATOR AND CAUSE DAMAGE TO THE EQUIPMENT.
 d) Remove the lockwire from the stator assembly nut.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 05 Page 525 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

737-300/400/500
MAINTENANCE MANUAL

SEE A
DOOR, 3701 TRIM ACCESS STABILIZER 
SEE  B 
SEE  F  SEE  C  SEE  D 
SLEEVE  SECONDARY BRAKE COVER 
STABILIZER TRIM ACTUATOR 

COVER BOLT (6 LOCATIONS)
FWD
STABILIZER TRIM ACTUATOR ASSEMBLY
A

Stabilizer Trim Actuator Secondary Brake Adjustment
Figure 505 (Sheet 1)

L30032
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 02 Page 526 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
LOWER STOP SCREW  LOWER 
(2 LOCATIONS)  STOP 
PACKING 

CAP
UMBRELLA
LOWER STOP ASSEMBLY
B

SEE E
A
STATOR ASSEMBLY
UMBRELLA SEAL ASSEMBLY C
STATOR ASSEMBLY NUT
A
STATOR ASSEMBLY (TOP VIEW)
D
LOCKWIRE
LOCKWIRE DETAIL E
Stabilizer Trim Actuator Secondary Brake Adjustment Figure 505 (Sheet 2)
SCREW (6 LOCATIONS)
SECONDARY BRAKE COVER
STATOR ASSEMBLY WASHER
L30858
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 01 Page 527 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
STATOR ASSEMBLY NUT SPRING WASHER
STATOR ASSEMBLY WASHER
ROTOR
STATOR
STATOR
ROTOR
STATOR
STATOR

Stabilizer Trim Actuator Secondary Brake Adjustment
Figure 505 (Sheet 3)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 01 Page 528 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
L31700
A 
737-300/400/500MAINTENANCE MANUAL
 e)  Place the fasteners through the stator housing and the
 gearbox housing.
 f)  Loosen the stator assembly nut until brake slippage
 occurs at 400 pound-inches or less.
 g)  Tighten the stator assembly nut until brake slippage
 does not begin to occur until between 550 - 650
 pound-inches.
 h)  Use a pen to mark the relative position of the stator
 assembly nut to the stator housing.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(86)