S 092-027

 (6)  
Remove the rig pin E-2.

 S 862-028

 (7)  
Release the pressure in the auxiliary pitot systems No. 1 and No. 2 (AMM 34-11-00/201).

 TASK 27-31-17-712-030
 5. Operational Test - Elevator Feel Unit
_____________________________________
 A. References
 (1)  AMM 06-09-05/201, Body Section 48 Access Doors and Panels
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-17
 ALL  ú ú 01 Page 209 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (2)
AMM 24-22-00/201, Manual Control

 (3)
AMM 29-11-00/201, Main Hydraulic Supply System

 (4)
AMM 34-11-00/201, Pitot Static System

 (5)
AMM 22-10-00/501, Autopilot/Flight Director System

 (6)
AIPC 27-31-17, Fig. 2

 B.
Access

 (1)  
Location Zone
 315 Area Aft of Stabilizer Box Compartment, LH
 316 Area Aft of Stabilizer Box Compartment, RH

 (2)  
Access Panel
 315A Access Door

 C.
Prepare for Test

 S 862-031
 (1) Do this task: "Supply Electrical Power" (AMM 24-22-00/201).
 S 862-033
 CAUTION: DO NOT PRESSURIZE THE AUXILIARY PITOT SYSTEM TO MORE THAN 4.00
_______ PSIG (OR 395 KNOTS). MAKE SURE THE PRESSURE CHANGE IS LESS THAN 5000 FEET (OR 300 KNOTS IAS) FOR EACH MINUTE FOR THE PITOT SYSTEM. THESE ARE TO PREVENT THE DAMAGE TO THE ELEVATOR FEEL COMPUTER WHICH IS A VERY EASILY DAMAGED INSTRUMENT.
 (2) Pressurize the auxiliary pitot static systems No. 1 and No. 2 to
 1.00 +1.00/-0.00 psi (or 204 +80/-0 knots IAS. Note: reference static pressure to ambient pressure.)(AMM 34-11-00/201).
 NOTE: This is to make sure the control column returns to the
____ center detent after movement as well to provide increased column force to simulate higher airspeeds.
 S 862-034
 WARNING: MOVE ALL PERSONS AND EQUIPMENT AWAY FROM THE RUDDERS AND THE
_______ ELEVATORS BEFORE YOU PRESSURIZE THE HYDRAULIC SYSTEMS. THE RUDDERS AND THE ELEVATORS CAN MOVE QUICKLY AND CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (3) Pressurize the hydraulic systems No. 2 and 3 (AMM 29-11-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-31-17
 ALL  ú ú 01 Page 210 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 282-035
 (4)  
Make sure that the stabilizer is at 5 units of trim.

 D.
Do the Elevator Feel Unit Operational Test

 S 712-036
 (1)  
Move the control column from the center detent slowly to the full aft position and make sure these conditions occur:

 (a)  
The force increases while the control column moves away from the neutral position.

 (b)  
The breakout force is approximately 8.6 pounds.

 (c)  
The force is at 72-106 pounds when the control column is in the aft position.

 S 862-040
 (2)  
Let the control column go back to the neutral position.

 S 862-041

 (3)  
Hold the STAB TRIM ALTN switches on the control stand to the APL NOSE UP position.

 S 712-042

 (4)  
Move the control column slowly to the full aft position and make sure these conditions occur:

 (a)  
Make sure that the breakout force is approximately 8.6 pounds.

 NOTE: The force increases at a rate that is less than the rate
____
 in step (1).

 (b)  
The force is at 40-55 pounds when the control column is at the full aft position.

 (5)  
Examine the hydraulic line connections for leaks.

 S 862-046

 (6)  
Use the STAB TRIM ALTN switches on control stand to set the horizontal stabilizer to the neutral rig position (3 units of trim).

 S 792-045
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(94)