(3)
 Put blanking caps on the electrical connector and the receptacle (12).

 (4)
 Remove the bolts (3).

R (5) Install the EXTRACTOR - FUEL PUMP (558-1-05903) or the EXTRACTOR TOOL R (558-1-05903-002) on the applicable fuel pump as follows:
 (a)
 Install the screws (22) into the tooling holes (10). CAUTION : YOU MUST USE THE TOOLING HOLES WHEN YOU INSTALL THE

_______ EXTRACTOR TOOL. THIS WILL PREVENT LEAKAGE OF FUEL FROM THE FUEL TANK.

 (b)
 Turn the knobs (24) together in small equal increments.

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-51Page 421 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 Fuel Pump 37QA(38QA) - Location and Detail
 Figure 403/TASK 28-21-51-991-002

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-51Page 422 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 Fuel Pump Extractor Tool
 Figure 404/TASK 28-21-51-991-003

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-51Page 423 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 (6)
 Turn the knobs (24) to move the slide valve apart from the pump canister.

 (7)
 Pull down on the handle (23) of the EXTRACTOR - FUEL PUMP until the movement of the fuel pump (2) and the slide-valve is stopped by the retainer pin-and-spring assembly.

 NOTE : The fuel inlet is closed when the slide valve movement is
____
 completed.

 (8) Use the EXTRACTOR - FUEL PUMP to turn the fuel pump (2) and slide-valve assembly counterclockwise until the head of the retainer pin is clear of the slot in the fuel pump flange.
R (9) Remove the EXTRACTOR - FUEL PUMP from the fuel pump (2).
 (10)
 Put the container in position below the pump drain hole. WARNING : CUT, REMOVE AND DISCARD THE LOCKWIRE AS YOU DO THE TASK.

_______ LOOSE LOCKWIRE CAN CUT OR BLIND YOU.

 (11)
 Remove and discard the lockwire from the drain bolt (6).

 (12)
 Hold the fuel pump (2) and remove the drain bolt (6) and the O-ring (7).

 (13)
 Drain approximately 0.5 l (0.132 USgal) of fuel from the fuel pump

 (2) and the fuel pump canister into the container.

 (14)
 Monitor the fuel that drains from the pump drain hole. If the fuel that flows from the pump drain hole is more than approximately 0.5 l (0.1320 USgal), do this procedure:

 NOTE : This will make sure that the slide valve seal is correctly
____
 positioned.

 (a)
 Install the drain bolt (6) and the O-ring (7).

 (b)
 Use the EXTRACTOR TOOL to turn the fuel pump (2) and the slide valve clockwise. Align the stop pin in the slide valve flange, with the stop pin location hole in the canister.

 (c)
 Make sure that the slot in the flange of the fuel pump (2) engages with the retaining pin and spring assembly.

 (d)
 Push the fuel pump (2) and the slide valve up and fully into the fuel pump canister.

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-51Page 424 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 (e)
 Do steps (5) thru (9) again and remove the fuel pump (2) and slide valve from the canister again.

 (f)
 Hold the fuel pump (2) and remove the drain bolt (6) and the O-ring (7).

 (g)
 Drain all fuel from the fuel pump (2) into the container.

 (15) Monitor the fuel that drains from the pump drain hole again.If the fuel that flows from the pump drain hole is more than approximately
 0.5 l (0.1320 USgal), do this procedure:
 (a)
 Install the drain bolt (6) and the O-ring (7).

 (b)
 Defuel the center tank (Ref. TASK 28-25-00-650-001).

 (c)
 Hold the fuel pump (2). Remove the drain bolt (6) and the O-ring (7). Discard the O-ring (7).

 (d)
 Drain all fuel from the fuel pump (2) into the container.

 (16) Record the position of the electrical receptacle (12). R (17) Install the hooks (21) of the EXTRACTOR - FUEL PUMP in the holes (4).
 (18)
 Turn the baulk-arm (11) of the fuel pump retainer until it is clear of the fuel pump flange.

 (19)
 Pull down on the handles (23) to remove the fuel pump (2). NOTE : The fuel-pump slide-valve stop-pin will not let the slide

____ valve be pushed in. The slide-valve fuel-inlet will stay closed until the slide-valve is turned during the fuel pump installation procedure.

 (20)
 Remove the EXTRACTOR - FUEL PUMP.

 (21)
 Examine the fuel pump (2) and the adjacent aircraft structure for signs of fuel leakage.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油3(67)