-
IN YOUR EYES
-ON YOUR SKIN FOR A LONG TIME.
AIRCRAFT FUEL IS POISONOUS.
WARNING : MAKE SURE THAT YOU HAVE THE CORRECT FIRE FIGHTING EQUIPMENT
_______ AVAILABLE.
1. Reason for the Job__________________ Self Explanatory
2. Job Set-up Information______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps No specific blanking plugs No specific circuit breaker(s) safety clip(s) No specific container 2.0 L No specific access platform 3.5 m (11 ft. 6 in.)
R EFF : 001-049, 101-105, 107-107, 151-199, 49-23-51Page 401 201-210, Config-2 Aug 01/05
CES
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
Power 28-00-00-910-001 Fuel Safety Procedures 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
Configuration before Maintenance Action 52-41-00-010-001 Open the APU Doors for Access 49-23-51-991-006 Fig. 401
3. Job Set-up
__________ Subtask 49-23-51-941-056
A. Safety Precautions
(1)
Obey the Fuel Safety Precautions (Ref. TASK 28-00-00-910-001). Subtask 49-23-51-860-057
B.
Aircraft Maintenance Configuration
(1)
Energize the ground service network
(Ref. TASK 24-42-00-861-001).
(2)
On the panel 25VU, make sure that the APU MASTER SW p/bsw OFF.
(3)
Put a warning notice in the cockpit to tell persons not to start the APU.
(4)
Make sure that hydraulic systems are depressurized
(Ref. TASK 29-00-00-864-001).
Subtask 49-23-51-865-063
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41
R EFF : 001-049, 101-105, 107-107, 151-199, 49-23-51Page 402 201-210, Config-2 Aug 01/05
CES Subtask 49-23-51-010-058
D. Get Access
(1)
Put the access platform in position below the APU access doors 315AL and 316AR.
(2)
Open the APU access doors 315AL and 316AR (Ref. TASK 52-41-00-010-001).
(3)
Set the LIGHT control SW 11LJ to the ON position.
4. Procedure
_________
(Ref. Fig. 401/TASK 49-23-51-991-006) Subtask 49-23-51-020-057
A. Removal of the IGV Actuator.
(1)
Disconnect the electrical connection (6).
(2)
Put blanking caps on the disconnected electrical connectors.
(3)
Put the container 2.0 L in position below the inlet guide vane-actuator.
(4)
Loosen the captive bolts (1).
(5)
Turn the captive plate (2) to release the fuel pipes (3) and (16).
(6)
Disconnect the fuel pipes (3), (16) and (18) from the inlet guide vane-actuator.
(7)
Remove and discard the O-rings (4), (15) and (17).
(8)
Put blanking plugs on the disconnected line ends.
(9)
Loosen the bolts (9) and turn the cover (11).
(10)
Loosen the captive bolt (10) to disconnect the IGV eye end (7) from the IGV actuation rod (8).
(11)
Remove the bolts (13), the washers (12) and remove the IGV actuator
(5) from the APU.
R EFF : 001-049, 101-105, 107-107, 151-199, 49-23-51Page 403 201-210, Config-2 Aug 01/05
CES
Actuator - Inlet Guide Vanes
Figure 401/TASK 49-23-51-991-006
CES TASK 49-23-51-400-004
Installation of the Inlet Guide Vane - Actuator (8014KM) (131-9(A))
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 機載輔助動力 AIRBORNE AUXILIARY POWER3(125)
