(21) and nuts (20).

 (2)
 Adjust the spray nozzles to spray into the power section compressor and the load compressor.

 (3)
 Make sure that the spray nozzle assembly is correctly installed and tightened.

 WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
 WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THE
_______
 SPECIAL MATERIAL.
 THIS MATERIAL IS DANGEROUS.

 WARNING : USE A PROTECTIVE EYE SHIELD/GOGGLES WHEN YOU USE COMPRESSED
_______ AIR. DEBRIS AND/OR HIGH PRESSURE AIR CAN DAMAGE YOUR EYES.
 (4) Prepare 18.0 l (4.7550 USgal) of the compressor wash-cleaner solution.
 (a)
 Mix 12.0 l (3.1700 USgal) of the de-mineralized water and 6.0 l (1.5850 USgal) of the solvent CLEANING AGENTS (Material No. 11-013) to make the cleaner solution.

 (b)
 Fill the container of the compressor cleaning device with 9.0 l (2.3775 USgal) of the cleaner solution.

 (c)
 Close the container and make sure that it is correctly sealed.

 (d)
 Operate the handpump on the compressor cleaning device and pressurize the container to 5 bar (72.5188 psi).

 Cleaning of the APU Compressor.
 Figure 702/TASK 49-20-00-991-003

 CES

 CAUTION : MAKE SURE THAT YOU HAVE THE CORRECT FIRE FIGHTING
_______ EQUIPMENT AVAILABLE. THE APU FIRE EXTINGUISHING SYSTEM IS NOT SUFFICIENT TO EXTINGUISH A FIRE IF THE ACCESS DOORS 315AL AND 316AR ARE OPEN/ REMOVED. KEEP OPERATION OF THE APU TO A MINIMUM WHEN THE ACCESS DOORS ARE OPEN/REMOVED.
 (5) Start and operate the APU (Ref. TASK 49-00-00-860-003).
 NOTE : APU run with open doors:
____
 -
make sure that the access platform can not move.

 -
make sure that the fire fighting equipment and the necesary persons to monitor the start and operation of the APU are available.

 -
make sure that no persons or loose equipment are in the danger areas.

 -
make sure that persons are not in the APU compartment or on the access platform below the APU during start, mode change (MES on/off, de-ice on/off, ECS demand change, APU Gen. on/off) and/or shutdown.

 (6)
 Do a print-out of the APU MES/IDLE REPORT <13> (Ref. TASK 31-36-00-740-010).

 (7)
 Spray the cleaner fluid into the APU compressor until the compressor cleaning device is empty.

 NOTE : Keep the pressure in the compressor cleaning device to
____ approximately 5 bar (72.5188 psi). Use a handpump to do this.
 (8)
 Operate the APU for 2 minutes with no cleaner fluid in the APU
 compressor.

 (9)
 Make sure that the pressure is released from the compressor cleaning device before the container is opened.

 (10)
 Fill the compressor-cleaning device container with 9.0 l (2.3775 USgal) of the cleaner solution.

 (11)
 Close the container and make sure that it is correctly sealed.

 (12)
 Operate the handpump on the compressor cleaning device and pressurize the container to 5 bar (72.5188 psi).

 (13)
 Spray the cleaner solution into the APU compressors for a second time until the cleaning device is empty.

 NOTE : Keep the pressure in the compressor cleaning device to
____ approximately 5 bar (72.5188 psi). Use a handpump to do this.
 (14)
 Operate the APU for 10 minutes more to make sure that the bleed components are dry.

 (15)
 Do a print-out of the APU MES/IDLE REPORT <13> (Ref. TASK 31-36-00-740-010).

 (16)
 Stop the APU (Ref. TASK 49-00-00-860-004).

 (17)
 Compare the EGT and OAT figures before and after the compressor cleaning.

 (a)
 Make sure that there has been an improvement in engine performance.

 (b)
 If the results are unsatisfactory do the compressor cleaning procedure again.

 (18)
 Open, safety and tag this(these) circuit breaker(s):
 1KD, 2KD.

 (19)
 Remove the cleaning device:

 (a)
 Remove the knurled screws (17) and remove the cleaning device.

 (b)
 Remove the knurled srew (15) and the mount plate (14) from the APU rear lower mount boss.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM 機(jī)載輔助動力 AIRBORNE AUXILIARY POWER3(96)