C. Expendable Parts
 -------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
200 packing 78-31-51 02 -270 205 packing 78-31-51 02 -280
 D. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
 the Ground Connector 71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 78-30-00-081-041 Make the Thrust Reverser Serviceable after
 Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-30-00-710-040 Thrust Reverser Hydraulic System Bleed Procedure 78-31-51-991-304 Fig. 403
 3. Job Set-up
__________
 Subtask 78-31-51-860-055
 A. Aircraft Maintenance Configuration
 (1) On the center pedestal, on the ENG panel 115VU, make sure that a warning notice is in position to tell persons not to start the engine.
 F 『 EEFF : ALL E Page 42578-31-51
 E E May 01/05 ERE
ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 (2) On the overhead maintenance panel 50VU, make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off. Make sure that a warning notice is in position to tell persons not to energize the FADEC 1(2).
 (3) Make sure that the access platform is in position. Subtask 78-31-51-010-077
 B. Get Access
 (1) Make sure that the fan cowl doors are open (Ref. TASK 71-13-00-010-040): FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR
 Subtask 78-31-51-040-067
 C. Make sure that the thrust reverser is unserviceable (Ref. TASK 78-30-00-481-041).
 4. Procedure
_________
 (Ref. Fig. 403/TASK 78-31-51-991-304) Subtask 78-31-51-420-063
 A. Installation of the Filter Clogging Indicator
 (1) Lubricate the new preformed packings (200) and (205) with thrust reverser hydraulic fluid (Material No. CP2212).

 (2) Put the packing (200) on the clogging indicator (195).

 (3) Put the packing (205) on the clogging indicator (195).

 (4) Use the SOCKET (CH1540-0276) or SOCKET (M46104) and install the clogging indicator (195) in the clogging indicator port of the HCU (20).

 (5) TORQUE the clogging indicator (195) to between 132.72 and 150.36 lbf.in (1.49 and 1.69 m.daN).

 (6) Install the glass bowl (190) and the retaining ring (185) on the clogging indicator (195).

 F 『 EEFF : ALL E Page 42678-31-51
 E E May 01/05 ERE
ECES E F 『 EEFF : ALL E Page 42778-31-51

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 (7) Safety the retaining ring (185) with lockwire (Material No. CP8001) or lockwire (Material No. CP8002).
 5. Close-up________
 Subtask 78-31-51-100-052
 A. If hydraulic fluid has come in contact with any titanium part, clean the part as follows:
 (1) Wipe off the affected area with a clean, dry cloth or paper towel.
 WARNING : BEFORE THE USE OF SOLVENT, PROTECTIVE FILM OR SEALANT_______ CAREFULLY READ THE APPLICABLE "MATERIAL SAFETY DATA SHEET" AND FOLLOW ALL LISTED SAFETY AND HEALTH PRECAUTIONS. USE THESE PRODUCTS IN AN AREA OPENED TO THE AIR AND WEAR PROTECTION GLOVES. THESE PRODUCTS ARE FLAMMABLE AND VAPOR IS DANGEROUS. THEY MAY CAUSE IRRITATION OF EYES, NOSE, THROAT AND SKIN. HIGH CONCENTRATIONS MAY CAUSE WEAKNESS, HEADACHE, NAUSEA, DIZZINESS AND IMPAIRED JUDGEMENT.
R R R R R  (2) Wipe the affected area with a clean, dry cloth or paper towel made moist with isopropyl alcohol (Material No. CP1041) or acetone (Material No. CP1039) or stoddard solvent (Material No. CP2011) or ardrox 552 (Material No. CP2559) or turco ind 79 (Material No. CP2560) or mag-chem teksol (Material No. CP2566) or degreasol 99 R (Material No. CP2584) or mag-chem skysol (Material No. CP2656) .
 (3) Dry the area with a clean, dry cloth or paper towel.
 Subtask 78-31-51-410-071
 B. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.
 Subtask 78-31-51-440-062
 C. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041).

 E E May 01/05 E E ECES E Subtask 78-31-51-410-072

 F  『
 E  C F M  E
 E  E
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(40)