曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 A. Damage  No damage permitted If there is damage, replace the heatshield
 B. Security of  No defect permitted If there is defect, attachment replace the attachments
 2. Examine the fireproof coating for :
 A. Nick, scratch,  No damage permitted If you find some damage, gouge, peeling and repair the fireproof blister protective coating
 B. Discoloration No discoloration  If the surface is a pink
 permitted  color, repair the fireproof protective coating
 F 『 EEFF : ALL E Page 61978-32-11
 E E Feb 01/98 E E ECES E 5. Close-up

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

________ Subtask 78-32-11-410-055
 A. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.

 (2) Close the thrust reverser doors (Ref. TASK 78-36-00-410-040): FOR 1000EM1 451AL, 452AR FOR 1000EM2 461AL, 462AR

 Subtask 78-32-11-440-052
 B. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041). Subtask 78-32-11-410-056
 C. Close Access
 (1) Close the fan cowl doors (Ref. TASK 71-13-00-410-040):
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 (2) Remove the access platform(s).

 (3) Remove the warning notice(s).

 F 『 EEFF : ALL E Page 62078-32-11
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 DOOR - BLOCKER - MAINTENANCE PRACTICES
______________________________________ TASK 78-32-41-480-001 Installation of the Safety Sleeve on Blocker Door Actuator
 1. Reason for the Job

__________________
 Self Explanatory

 2. Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice No specific access platform 1 m (3 ft. 3 in.) HIX3005 1 SAFETY SLEEVE - PIVOTING DOOR ACTUATOR
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-32-41-860-001 Manual Deployment of the Blocker Door 78-32-41-991-301 Fig. 201
 3. Job Set-up
__________ Subtask 78-32-41-941-059
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 F 『 EEFF : ALL E Page 20178-32-41
 E E Feb 01/98 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 78-32-41-010-059
 B. Get Access
 (1) Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 (2) Put the access platform in position. Subtask 78-32-41-040-059

 C. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). Subtask 78-32-41-010-060

 D. Deploy the blocker door manually (Ref. TASK 78-32-41-860-001).
 4. Procedure
_________ (Ref. Fig. 201/TASK 78-32-41-991-301) Subtask 78-32-41-480-050
 A. Install the SAFETY SLEEVE - PIVOTING DOOR ACTUATOR (HIX3005) on the
 hydraulic actuator as follows:

 (1) Loosen the two knurled screws on the sleeve fully.

 (2) Move the half-sleeves apart.

 (3) Put the half-sleeves on the hydraulic actuator rod.

 (4) Tighten the two knurled screws until sleeve is firmly in place on the actuator.

 F 『 EEFF : ALL E Page 20278-32-41
 E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E

 

 Safety Sleeve Installation
 Figure 201/TASK 78-32-41-991-301

 F 『 EEFF : ALL E Page 20378-32-41
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(60)