Thrust-Reverser Hydraulic-Control-Unit Pressuring-Valve - Inhibition
Figure 006
F EEFF : ALL 『E 78-36-00 Page 8
E E Feb 01/98
E E
ECES E
F 『 E C F M E E E E 56-5B E
Thrust Reverser Lockout Bolt Installed
Figure 007
F 『 EEFF : ALL E Page 978-36-00
E E Feb 01/98 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
THRUST REVERSER OPENING MECHANISM - MAINTENANCE PRACTICES
_________________________________________________________
TASK 78-36-00-010-040
Opening of the Thrust Reverser Doors
CAUTION : DO NOT OPEN THE THRUST REVERSER DOORS IF THE WIND SPEED IS MORE THAN
_______
40 KNOTS.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific warning notice
No specific access platform 1 m (3 ft. 3 in.)
HIX4001 2 PUMP HAND COWL - ACTUATOR, FAN REVERSER
B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
Material No. CP2442 * R Mobil Jet Oil RM 254 (Ref. 70-30-00)
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors
78-30-00-481-041 Make the Thrust Reverser Unserviceable for
Maintenance
78-36-00-991-300 Fig. 201
78-36-00-991-301 Fig. 202
78-36-00-991-302 Fig. 203
F 『 EEFF : ALL E Page 20178-36-00
E E May 01/98 E E ECES E 3. Job Set-up
F 『
E C F M E
E E
E 56-5B E
E E
__________ Subtask 78-36-00-941-050
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 78-36-00-010-050
B. Get Access
(1) Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2) Put an access platform in position. Subtask 78-36-00-040-050
C. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). NOTE : Do not close the fan cowl doors.
____
F 『 EEFF : ALL E Page 20278-36-00
E E Feb 01/98 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
4. Procedure
_________
Subtask 78-36-00-010-051
A. Opening of the Thrust Reverser Doors CAUTION : DO NOT OPEN THE THRUST REVERSER DOORS IF THE WIND SPEED IS MORE
_______
THAN 40 KNOTS.
(1) Release each of the four door latches of the thrust reverser as follows:
(a) Push in on the snap to free the latch handle. (Ref. Fig. 201/TASK 78-36-00-991-300)
(b) Pull down on the latch handle to disengage the latch hook from its attachment point.
Subtask 78-36-00-020-050
B. Remove the cap:
(Ref. Fig. 202/TASK 78-36-00-991-301)
CAUTION : DO NOT USE A HYDRAULIC PUMP WITH A FLOW MORE THAN 3.66 IN.3.
_______ (60 CM3) PER EACH HAND PUMP TRAVEL OR DAMAGE OF THE HYDRAULIC JUNCTION BOXES COULD RESULT.
R CAUTION : ONLY USE MIL-L-23699C OIL IN HYDRAULIC HAND PUMP, USE OF ANY
_______ R OTHER COULD DAMAGE HYDRAULIC THRUST REVERSER COWL OPENING ACTUATOR.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(96)
