R TASK 78-32-00-210-046
R Detailed Visual Inspection of the Thrust Reverser Forward Frame at Actuator R Attachment
R NOTE : For maintenance planning purposes, this task should be accomplished at
____ R the same time as the MPD TASKS 783001-01-1, 783002-01-1 and 783003-01-1.
R 1. Reason for the Job
__________________ R Refer to the MPD TASK: 783004-02 R 2. Job Set-up Information
______________________
R A. Referenced Information
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R 78-32-11-000-002 Removal of the Left or Right Half Door of Thrust R Reverser R 78-32-11-400-002 Installation of the Left or Right Half Door of Thrust R Reverser R CMM 78-32-36
R 3. Job Set-up
__________ R Subtask 78-32-00-941-069 R A. Remove the thrust reverser doors (Ref. TASK 78-32-11-000-002) R 4. Procedure
_________ R Subtask 78-32-00-210-068 R A. Do a detailed visual inspection of the thrust reverser forward frame at
R actuator attachment. (Ref. CMM 78-32-36), Repair No.3 (Inspection,
R Removal Limits & Forward Frame).
R 5. Close-up
________ R Subtask 78-32-00-420-060 R A. Install the thrust reverser doors. (Ref. TASK 78-32-11-400-002).
F 『 EEFF : ALL E Page 61078-32-00
E E Feb 01/04 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
COWL - THRUST REVERSER - SERVICING
__________________________________ TASK 78-32-11-000-001 Removal of the One or Eleven O'clock Strut Bushing
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
No specific access platform 1 m (3 ft. 3 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. CP1039
Material No. CP1041
R R R R R R R R R R R R Material No. Material No. Material No. Material No. Material No. Material No. CP2011 CP2559 CP2560 CP2566 CP2584 CP2656
*
acetone (Ref. 70-30-00)
*
isopropyl alcohol (Ref. 70-30-00)
*
stoddard solvent (Ref. 70-30-00)
*
ardrox 552 (Ref. 70-30-00)
*
turco ind 79 (Ref. 70-30-00)
*
mag-chem teksol (Ref. 70-30-00)
*
degreasol 99 R (Ref. 70-30-00)
*
mag-chem skysol (Ref. 70-30-00)
F 『 EEFF : ALL E Page 30178-32-11
E E May 01/05 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
Maintenance 78-36-00-010-040 Opening of the Thrust Reverser Doors 78-32-11-991-301 Fig. 301
3. Job Set-up
__________ Subtask 78-32-11-941-050
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 78-32-11-869-050
B. Make sure that:
- the slats and flaps are retracted,
- the throttle control levers operate at minimum power (0 degree). Subtask 78-32-11-941-051
C. Put a warning notice on the slats and flaps control levers to prevent use of them.
F 『 EEFF : ALL E Page 30278-32-11
E E May 01/05 ERE
ECES E Subtask 78-32-11-010-050
F 『
E C F M E
E E
E 56-5B E
E E
D. Get Access
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(47)
