F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 Removal of the Safety Sleeve from Blocker Door Actuator
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice No specific access platform 1 m (3 ft. 3 in.) HIX3005 1 SAFETY SLEEVE - PIVOTING DOOR ACTUATOR
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 78-30-00-081-041 Make the Thrust Reverser Serviceable after
 Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-32-41-860-002 Manual Stowing of the Blocker Door 78-32-41-991-301 Fig. 201
 3. Job Set-up
__________
 Subtask 78-32-41-860-052
 A. Aircraft Maintenance Configuration
 (1) On the center pedestal, on the ENG panel 115VU, make sure that a warning notice is in position to tell persons not to start the engine.
 F 『 EEFF : ALL E Page 20478-32-41
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 (2) On the overhead maintenance panel 50VU, make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off. Make sure that a warning notice is in position to tell persons not to energize the FADEC 1(2).
 (3) Make sure that the access platform is in position. Subtask 78-32-41-010-062
 B. Make sure that the fan cowl doors are open (Ref. TASK 71-13-00-010-040): FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR
 Subtask 78-32-41-040-061
 C. Make sure that the thrust reverser is unserviceable (Ref. TASK 78-30-00-481-041).
 4. Procedure
_________
 (Ref. Fig. 201/TASK 78-32-41-991-301) Subtask 78-32-41-080-050
 A. Remove the SAFETY SLEEVE - PIVOTING DOOR ACTUATOR (HIX3005) from the hydraulic actuator as follows:
 (1) Fully loosen the two knurled screws on sleeve.

 (2) Pull the half-sleeves apart.

 (3) Remove the half-sleeves from the hydraulic actuator.

 (4) Tighten the knurled screws.

 5. Close-up
________ Subtask 78-32-41-410-060
 A. Stowing of the Blocker Door CAUTION : BLOCKER DOOR LATCH MUST BE OPENED WHEN YOU CLOSE THE BLOCKER
_______
 DOOR OR DAMAGE CAN OCCUR.

 (1) Stow the blocker door manually (Ref. TASK 78-32-41-860-002).
 F 『 EEFF : ALL E Page 20578-32-41
 E E Feb 01/98 E E ECES E Subtask 78-32-41-440-059

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 B. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041). Subtask 78-32-41-410-061
 C. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.

 (2) Close the fan cowl doors (Ref. TASK 71-13-00-410-040):
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 (3) Remove the access platform(s).

 (4) Remove the warning notice(s).

 F 『 EEFF : ALL E Page 20678-32-41
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 TASK 78-32-41-860-001 Manual Deployment of the Blocker Door
 1. Reason for the Job

__________________
 Self Explanatory

 2. Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
 No specific access platform 1 m (3 ft. 3 in.)

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 2(61)