(2)
Put the warning notice(s) in position to tell persons not pressurize the Green hydraulic system: - on the panel 40VU in the cockpit, - on the ground service panel of the Green hydraulic system, access
door (197CB).
(3)
Put the safety barriers in position.
(4)
Put a container for hydraulic fluid in position.
(5)
Obey the applicable safety precautions before you open the LGCIU circuit breakers (Ref. TASK 32-00-00-860-001).
Subtask 32-21-11-865-058
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
R **ON A/C 051-099,
R 121VU HYDRAULIC/TIRE/PRESS 1GV M31
1EFF : ALL 1 32-21-11Page 403 1 1 May 01/05 1 1 1CES 1 1EFF : ALL 1 32-21-11Page 404 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 32-21-11Page 405 1 1 Aug 01/05 1 1 1CES 1
**ON A/C ALL
Subtask 32-21-11-010-053
C. Get Access
(1) Open the doors of the nose landing gear (Ref. TASK 32-22-00-010-001).
(2) Put the access platform in position in zone 123.
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
Subtask 32-21-11-860-053
D. Aircraft Maintenance Configuration
(1) Make sure that the Green hydraulic system is depressurized and put it in the maintenance configuration. (Ref. TASK 29-00-00-864-001)
(2) Depressurize the reservoir of the Green hydraulic system. (Ref. TASK 29-14-00-614-001)
(3) Depressurize the nose gear shock absorber. To do this act on the charging valve at the top of the shock absorber, as follows:
(a) Remove the blanking cap from the charging valve.
(b) Slowly open the valve by one and a half turns maximum.
(4) Lift the aircraft with jacks (Ref. TASK 07-11-00-581-001).
(5) Use a spatula to remove sealants from the mechanicals parts.
R **ON A/C 401-499,
R Subtask 32-21-11-860-053-A
R D. Aircraft Maintenance Configuration
R R R (1) Make sure that the Yellow hydraulic system is depressurized and put it in the maintenance configuration. (Ref. TASK 29-00-00-864-001)
R (2) Depressurize the reservoir of the Yellow hydraulic system.
R (Ref. TASK 29-14-00-614-001)
R (3) Depressurize the nose gear shock absorber. To do this act on the
R charging valve at the top of the shock absorber, as follows:
R (a) Remove the blanking cap from the charging valve.
R (b) Slowly open the valve by one and a half turns maximum.
R (4) Lift the aircraft with jacks (Ref. TASK 07-11-00-581-001).
R (5) Use a spatula to remove sealants from the mechanicals parts.
R **ON A/C ALL
4. Procedure_________
(Ref. Fig. 401/TASK 32-21-11-991-008, 402/TASK 32-21-11-991-009, 403/TASK
32-21-11-991-010, 404/TASK 32-21-11-991-011, 405/TASK 32-21-11-991-012,
406/TASK 32-21-11-991-013-A)
Subtask 32-21-11-020-054
A. Preparation of the NLG before Removal
(1) Remove the NLG aft doors (Ref. TASK 32-22-13-000-001).
(2) Remove the leg door assy (Ref. TASK 32-22-15-000-001).
(3) Remove the swivel selector valve (Ref. TASK 32-51-15-000-001).
(4) Remove the NLG wheels 2659GM, 2660GM (Ref. TASK 32-41-12-000-001).
(5) Remove the taxi light 8LR (Ref. TASK 33-46-12-000-001).
(6) Remove the take-off light 7LR (Ref. TASK 33-46-11-000-001).
(7) Remove the runway turnoff light (Ref. TASK 33-43-11-000-001).
(8) Remove the towing fitting (Ref. TASK 32-21-41-000-001).
Installation of the Tool Figure 401/TASK 32-21-11-991-008
1EFF : 1 1R 1CES ALL 1 11 1 32-21-11 Page 406 Aug 01/05
Electrical and Hydraulic Connections Figure 402/TASK 32-21-11-991-009
1EFF : 1 1R 1CES ALL 1 11 1 32-21-11 Page 407 Aug 01/05
中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架3(71)
