2. In the cockpit, on the ECAM In the cockpit, on the lower ECAM
control panel: display unit:
-push the DOOR membrane switch. - the DOOR/OXY status page comes on.
-the DOOR symbols are shown in green and the SLIDE messages are shown in white.
3.
In the cockpit on the secondary
circuit breaker panel 121VU:
- open the circuit breakers 13WN - the DOOR symbols become amber and the and 15WN. SLIDE messages go out of view.
4.
In the cockpit on the SIGNS panel
25VU:
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 33-51-00Page 545 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-
set the EMER EXIT LT switch 4WL - the DOORS symbols become green and to the ON position. the SLIDE messages come into view.
-
set the EMER EXIT LT switch 4WL - the DOOR symbols become amber and the to the OFF position. SLIDE messsages go out of view.
5. In the cockpit, on the secondary circuit breaker panel 121VU:
-close the circuit breakers 13WN
and 15WN.
On all passenger/crew doors:
-put the escape-slide control
handle to the DISARMED
position.
-install the safety pin.
**ON A/C 301-399,
Subtask 33-51-00-710-054-A
B. Test of the door-switch power supplies with the EMER-EXIT LT switch 4WL
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : DO NOT OPEN THE PASSENGER/CREW DOORS.
_______
NOTE : The time taken to do this test should not exceed 3 minutes to
____ prevent discharge of the emergency lighting batteries.
R 1EFF : ALL 1 33-51-00Page 546 1 1 Aug 01/05 1 1 1CES 1
(1) Do this test.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On all passenger/crew doors and emergency exit doors:
-remove the safety pins.
-put the escape-slide control handle to the ARMED position.
2. In the cockpit, on the ECAM control panel:
-push the DOOR membrane switch.
3.
In the cockpit on the secondary circuit breaker panel 121VU:
- open the circuit breakers 13WN and 15WN.
4.
In the cockpit on the SIGNS panel 25VU:
-
set the EMER EXIT LT switch 4WL to the ON position.
-
set the EMER EXIT LT switch 4WL to the OFF position.
5.
In the cockpit, on the secondary circuit breaker panel 121VU:
-close the circuit breakers 13WN and 15WN.
On all passenger/crew doors and emergency exit doors:
-put the escape-slide control handle to the DISARMED position.
-install the safety pin.
In the cockpit, on the lower ECAMdisplay unit:
-
the DOOR/OXY status page comes on.
-
the DOOR symbols are shown in green and the SLIDE messages are shown in white.
-
the DOOR symbols become amber and theSLIDE messages go out of view.
-
the DOORS symbols become green andthe SLIDE messages come into view.
-
the DOOR symbols become amber and theSLIDE messsages go out of view.
R 1EFF : 301-399, 1 33-51-00Page 547 1 1 Aug 01/05 1 1 1CES 1
**ON A/C ALL
Subtask 33-51-00-720-050
C. Test of the FWD and AFT passenger/crew door switches of the
emergency-exit escape-slide lighting.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(122)
