R (c) Install the module housing (6) in the top track (4).
R Make sure that you hear a click when the module housing (6) locks
R in position.
R Subtask 33-51-12-710-050
R C. Do the operational test of the cabin emergency lighting (Ref. TASK 33-51-
R 00-710-002).
R 5. Close-up________
R Subtask 33-51-12-860-054
R A. Put the aircraft back to the serviceable condition.
R (1) Make sure that the work area is clean and clear of tool(s) and other
R items.
SIGN - EXIT MARKING, WALL MOUNTED - REMOVAL/INSTALLATION
________________________________________________________
TASK 33-51-13-000-001
Removal of the Cabin Wall-Mounted Emergency-Exit-Markers
WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______
YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
NOTE : The procedure is the same for all wall-mounted emergency-exit-markers.
____
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific insertion/removal tool M 15.570-22
No specific insertion/removal tool M15.570-22
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C 001-049, 101-149, 201-299,
33-51-13-991-001 Fig. 401
**ON A/C 051-099,
33-51-13-991-001-E Fig. 401A -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
**ON A/C 151-199,
33-51-13-991-001-B Fig. 401B
**ON A/C 301-302,
33-51-13-991-001-D Fig. 401C R **ON A/C 303-399,
R 33-51-13-991-001-F Fig. 401D **ON A/C ALL
3. Job Set-up
__________
Subtask 33-51-13-865-050
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU LIGHTING/EMER LT/CABIN 2WL H06 49VU LIGHTING/EMER LT/CABIN 1WL H05
Subtask 33-51-13-860-050
B. Aircraft Maintenance Configuration
(1)
On the overhead panel 25VU, make sure that the EMER EXIT LT switch 4WL is in the OFF position.
(2)
On the overhead panel 25VU, make sure that the NO SMOKING switch 190RH is in the OFF position.
(3)
On the Forward Attendant Panel (FAP) 120RH, make sure that the LIGHT EMER pushbutton switch and its integral light are off.
R 4. Procedure_________ **ON A/C 001-049, 101-149, 201-299,
(Ref. Fig. 401/TASK 33-51-13-991-001) **ON A/C 051-099,
(Ref. Fig. 401A/TASK 33-51-13-991-001-E) **ON A/C 151-199,
(Ref. Fig. 401B/TASK 33-51-13-991-001-B) **ON A/C 301-302,
R (Ref. Fig. 401C/TASK 33-51-13-991-001-D) **ON A/C 303-399,
R R (Ref. Fig. 401D/TASK 33-51-13-991-001-F) **ON A/C 001-049, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 33-51-13-020-050
A. Removal of the Wall-Mounted Emergency-Exit-Marker (1) Remove the screws (1), the washers (2) and lower the emergency exit marker (3) sufficient to get access to the electrical connections (4). (2) Disconnect the electrical connections (4) with the insertion/removal tool M15.570-22.
(3) Remove the wall-mounted emergency-exit-marker (3).
Cabin Wall-Mounted Emergency-Exit-Markers
Figure 401/TASK 33-51-13-991-001
R 1EFF : 001-049, 101-149, 201-299, 1 33-51-13Page 404 1 1 Aug 01/05 1 1 1CES 1
R Cabin Wall-Mounted Emergency-Exit-Markers
R Figure 401A/TASK 33-51-13-991-001-E
R 1EFF : 051-099, 1 33-51-13 Page 405
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(139)
