(b)
Subtract the vertical value 2.2 m (7.21 ft.) from the distance "X". This gives you the value "Y", which is the distance between the ground and the target on the screen. You must adjust the light beam to the center of the target.
(c)
Tighten or loosen the nuts (1) of the lower fork to adjust the light beam on the target.
(d)
Tighten the nuts (1) and make sure that the adjustment is correct.
(e)
Safety the nuts (1) together with MISCELLANEOUS (Material No. 19-010).
5. Close-up
________
Subtask 33-46-11-865-065
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 3LR
Adjustment of the Take Off Light - Alternative Procedure Figure 502/TASK 33-46-11-991-005- 12 (SHEET 1)
1EFF : 051-051, 1 33-46-11Page 508 1 1 May 01/05 1 1 1CES 1
Adjustment of the Take Off Light - Alternative Procedure Figure 502/TASK 33-46-11-991-005- 22 (SHEET 2)
1EFF : 051-051, 1 33-46-11Page 509 1 1 May 01/05 1 1 1CES 1 LIGHT - TAXI (8LR) - REMOVAL/INSTALLATION
_________________________________________
TASK 33-46-12-000-001
Removal of the Taxi Light (8LR)
WARNING : WEAR GLASSES AND PROTECTIVE CLOTHING WHEN YOU WORK ON THE LIGHT.
_______
WARNING : DO NOT DISCONNECT THE ELECTRICAL CONNECTIONS FOR AT LEAST 2 MINUTES
_______
AFTER YOU DE-ENERGIZE THE ELECTRICAL CIRCUITS.
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps
No specific circuit breaker(s) safety clip(s)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
**ON A/C 001-049, 052-060, 101-101,
33-46-12-991-001-B Fig. 401
**ON A/C 051-051,
33-46-12-991-001 Fig. 401A R **ON A/C 061-099, 102-149, 151-199, 201-299, 301-399, 401-499,
33-46-12-991-001-A Fig. 401B
**ON A/C ALL
3. Job Set-up
__________
Subtask 33-46-12-865-050
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
122VU LIGHTING/EXT LT/TAXI AND TAKE OFF/TAXI 1LR W08
4. Procedure
_________
Subtask 33-46-12-020-050
A. Removal of the Taxi Light
**ON A/C 001-049, 052-060, 101-101,
(Ref. Fig. 401/TASK 33-46-12-991-001-B)
**ON A/C 051-051,
(Ref. Fig. 401A/TASK 33-46-12-991-001) R **ON A/C 061-099, 102-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 401B/TASK 33-46-12-991-001-A)
**ON A/C ALL
(1)
Disconnect the electrical connector (12) from the socket (11).
(2)
Put the blanking caps on the disconnected electrical connector (12) and the socket (11).
(3)
Remove the nut (6), the washer (7), the screw (9) and the washer (8).
(4)
Remove the nuts (5), the washers (4), the screws (1) and the washers (2). During this operation, hold the light (10).
Taxi Light Figure 401/TASK 33-46-12-991-001-B
R 1EFF : 001-049, 052-060, 101-101, 1 33-46-12Page 403 1 1 May 01/05 1 1 1CES 1
R Taxi Light
R Figure 401A/TASK 33-46-12-991-001
R 1EFF : 051-051, 1 33-46-12 Page 404
1 1 May 01/05
1 1
1CES 1
Taxi Light
Figure 401B/TASK 33-46-12-991-001-A
R 1EFF : 061-099, 102-149, 151-199, 201-299, 1 33-46-12Page 405 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1 中國航空網(wǎng) www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(27)
