(c) Apply SPECIAL MATERIALS (Material No. 05-065) to cover the crack(s).
NOTE : Make sure that the tape is correctly installed and has no
____ bubbles, wrinkles or tears in it.
(d) Let the tape cure for 15 minutes minimum at a minimum temperature of 15 deg.C (59.00 deg.F).
(3) If it is not necessary to replace the take off light, write in the aircraft technical log that the take off light is damaged.
5. Close-up
________ Subtask 33-46-00-865-056 R A. Make sure that this(these) circuit breaker(s) is(are) open, safetied and R tagged 3LR Subtask 33-46-00-942-054
B. Put the aircraft back to its initial configuration.
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the warning notice(s).
R TASK 33-46-00-440-002
R Reactivation of the Take Off Light (7LR)
R 1. Reason for the Job__________________
R Refer to the CDL TASK: 33-9
R Take Off Light
R 2. Job Set-up Information______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------
R REFERENCE QTY DESIGNATION
R -------------------------------------------------------------------------------
R No specific circuit breaker(s) safety clip(s)
R B. Referenced Information
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R 33-46-11-000-001 Removal of the Take Off Light (7LR)
R 33-46-11-400-001 Installation of the Take Off Light (7LR)
R 3. Job Set-up__________
R Subtask 33-46-00-941-053
R A. Safety Precautions
R (1) Put a warning notice in position on the EXT LT section of the
R overhead panel 25VU to tell persons not to operate the take off
R light.
R Subtask 33-46-00-865-057
R B. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------
R PANEL DESIGNATION IDENT. LOCATION
R -------------------------------------------------------------------------------
R 122VU LIGHTING/EXT LT/TAXI AND TAKE OFF/TO 3LR W07
R 4. Procedure_________
R Subtask 33-46-00-440-051
R A. Reactivation of the Take Off Light
R (1) Replace the take off light (Ref. TASK 33-46-11-000-001) and
R (Ref. TASK 33-46-11-400-001).
R 5. Close-up________
R Subtask 33-46-00-865-058
R A. Remove the safety clip(s) and the tag(s) and close this(these) circuit
R breaker(s):
R 3LR
R Subtask 33-46-00-942-055
R B. Put the aircraft back to its initial configuration.
R (1) Make sure that the work area is clean and clear of tool(s) and other
R items.
R (2) Remove the warning notice(s).
TAXI AND TAKE OFF LIGHTS - ADJUSTMENT/TEST
__________________________________________ TASK 33-46-00-710-001 Operational Test of the Taxi and Take Off Lights
1. Reason for the Job
__________________
Make sure that the taxi and take off lights operate correctly.
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊(cè) AMM LIGHTS 燈光2(21)
