曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R R  (b) Turn the locking handle up to the locked position and push it into the recess of the handle flap. 
R R  (2) Make sure that the skin offset between the vent door and the cargo door contour is correct (Ref. TASK 52-31-11-820-003). 
R R  (3) Make sure that the clearance between the stop bolts of the vent door and the related stops is correct (Ref. TASK 52-31-11-820-003). 
R R  (4) Push the handle flap in and pull the locking handle out of the recess to open the vent door. 
R  (5) Turn the locking handle down to the unlocked position.

 

 5. Close-up
________
 Subtask 52-31-22-865-052

 A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1MJ, 3801GX, 3802GX, 3803GX
 Subtask 52-31-22-410-050
 B. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Make sure that the springs of the hinge arms are correctly lubricated (Ref. TASK 12-22-52-640-002).

 (3)
 Apply STORAGE PRESERVATION (Material No. 15-005) to all the components of the vent door and to the adjacent cargo door structure.

 (4)
 Install the removed parts of the lining and insulation (Ref. TASK 52-31-13-400-001).

 (5)
 Remove the actuator safety locks and close the FWD cargo door (Ref. TASK 52-30-00-860-002).

 (6)
 Remove the access platform(s).

 1EFF : ALL 1 52-31-22Page 416 1 1 May 01/05 1 1 1CES 1

 HARNESS - CARGO COMPARMENT DOOR - REMOVAL/INSTALLATION
______________________________________________________ TASK 52-31-24-000-001 Removal of the Wiring Harness 4611VB
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps
 No specific circuit breaker(s) safety clip(s)
 No specific access platform 3.5 m (11 ft. 6 in.)
 98D52307515000 1 SAFETY LOCK - ACTUATOR, CARGO DOORS

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the
 Yellow Electric Pump 52-31-13-000-001 Removal of the Lining and the Insulation 52-31-24-991-001 Fig. 401
 3. Job Set-up
__________ Subtask 52-31-24-010-050
 A. Get Access
 (1)
 Open the FWD cargo compartment door (referred to as cargo door) (Ref. TASK 52-30-00-860-001) and safety it with the SAFETY LOCK -ACTUATOR, CARGO DOORS (98D52307515000).

 (2)
 Put the access platform in position below the opened cargo door.

 1EFF : ALL 1 52-31-24Page 401 1 1 Feb 01/99 1 1 1CES 1

 (3) Remove the lining and insulation of the cargo door to get access to the terminal block 7526VT (Ref. TASK 52-31-13-000-001).
 Subtask 52-31-24-865-050
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 4. Procedure
_________ Subtask 52-31-24-020-050
 A. Removal of the Wiring Harness 4611VB
 (Ref. Fig. 401/TASK 52-31-24-991-001)

 (1)
 Disconnect the connector (29) from the receptacle (28).

 (2)
 Put blanking caps on the disconnected electrical connectors.

 (3)
 Disconnect the electrical cables of the wiring harness (1) from the terminal block (6).

 (4)
 Remove the nut (3), the bolt (5) and the clamp (4) from the door angle (2).

 (5)
 Remove the nut (12), the washer (11), the bolt (9) and the clamp (8) from the actuator fitting bracket (10).

 (6)
 Remove the nut (14) and the washer (15) from the bolt (17) and disconnect the clamp (16) from the bracket (18) in the actuator area.

 (7)
 Cut and remove the tie-raps (26) and disconnet the wiring harness (1) from the cable brackets (27) of the ceiling lining.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門4(156)