(3) Put the access platform in position below the opened cargo door. Subtask 52-32-18-865-050
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
 -------------------------------------------------------------------------------
121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 1EFF : ALL 1 52-32-18Page 402 1 1 Aug 01/05 1 1 1CES 1 Subtask 52-32-18-860-050

 C. Aircraft Maintenance Configuration
 (1)
 Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).

 (2)
 Depressurize the hydraulic reservoirs (Ref. TASK 29-14-00-614-001).

 (3)
 Depressurize the Yellow hydraulic system (Ref. TASK 29-10-00-864-002).

 4. Procedure
_________ R **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 Subtask 52-32-18-020-050-A
 A. Removal of the Door Seal and the Associated Components (Ref. Fig. 401/TASK 52-32-18-991-001-A, 402/TASK 52-32-18-991-002-A)
 (1)
 Disconnect the connector (20) from the receptacle (19) and remove the wire harness (21) from the door actuator area (Ref. TASK 52-32-24-000-001).

 (2)
 Disconnect the door actuators from the cargo door as follows:

 (a)
 Remove the nut (9), the washer (11), the bolt (12) and the bonding jumper (10) from the actuator attachment fitting (13).

 (b)
 Remove and discard the cotter pin (17) from the nut (16).

 (c)
 Remove the nut (16), the washer (15) from the bolt (14).

 (d)
 Hold the piston eye end (18) and remove the bolt (14) and the washer (25).

 (e)
 Disconnect the piston eye-end (18) from the actuator attachment fitting (13).

 (3)
 Pull the door seal (1) out of the retainer (2).

 1EFF : ALL 1 52-32-18Page 403 1 1 Aug 01/05 1 1 1CES 1

 Door Seal Figure 401/TASK 52-32-18-991-001-A
R 1EFF : 001-049, 053-099, 101-149, 151-199, 1 52-32-18Page 404 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1

R  Door Seal 
R  Figure 401A/TASK 52-32-18-991-001-B 
R 1EFF :  051-052,  1  52-32-18 Page 405 
1  1  May 01/05
 1  1
 1CES  1

 Disconnection of associated Components Figure 402/TASK 52-32-18-991-002-A
R 1EFF : 001-049, 053-099, 101-149, 151-199, 1 52-32-18Page 406 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1

R  **ON A/C 051-052, 
R  Subtask 52-32-18-020-050 
R  A. Removal of the Door Seal and the Associated Components 
R  (Ref. Fig. 401A/TASK 52-32-18-991-001-B, 402A/TASK 52-32-18-991-002) 
R  (1) Disconnect the connector (20) from the receptacle (19) and remove the 
R  wire harness (21) from the door actuator area (Ref. TASK 52-32-24-
R  000-001). 
R  (2) Remove the screws (6), the washers (7) and the bonding jumpers (8) 
R  from the upper fuselage door frame. 
R  (3) Disconnect the door actuators from the cargo door as follows: 
R  (a) Remove the nut (9), the washer (11), the bolt (12) and the 
R  bonding jumper (10) from the actuator attachment fitting (13). 
R  (b) Remove and discard the cotter pin (17) from the nut (16). 
R  (c) Remove the nut (16), the washer (15) from the bolt (14). 
R  (d) Hold the piston eye end (18) and remove the bolt (14) and the 
R  washer (25). 
R  (e) Disconnect the piston eye-end (18) from the actuator attachment 
R  fitting (13). 
R  (4) Pull the door seal (1) out of the retainer (2). 

R 1EFF : 051-052, 1 52-32-18Page 407 1 1 May 01/05 1 1 1CES 1

R  Disconnection of associated Components 
R  Figure 402A/TASK 52-32-18-991-002 
R 1EFF :  051-052,  1  52-32-18 Page 408 
1  1  May 01/05
 1  1
 1CES  1

R  **ON A/C ALL
 TASK 52-32-18-400-001
 Installation of the Door Seal
 1. Reason for the Job__________________
 Self Explanatory
 2. Job Set-up Information______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門5(68)