R  **ON A/C 401-499,
R  52-32-21-991-004-D Fig. 405D **ON A/C ALL
 3. Job Set-up
__________
 Subtask 52-32-21-010-052

 A. Get Access
 (1) Open the AFT cargo-compartment door (referred to as cargo door) and safety it with the actuator safety locks (Ref. TASK 52-30-00-860-001).
 (2) Put the access platform in position below the opened cargo door. Subtask 52-32-21-865-056
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
 **ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
 Subtask 52-32-21-010-053
 C. Get Access
 (1)
 Remove the access panel 826AR from the cargo door.

 (2)
 Remove the lining and the insulation of the cargo door to get access to the upper end of the gear box (Ref. TASK 52-32-13-000-001).

 1EFF : ALL 1 52-32-21Page 420 1 1 Aug 01/05 1 1 1CES 1

 (3) Remove the vent door cover from the internal door structure to get access to the actuator arm of the vent door. 
R  **ON A/C 151-199, 401-499,
 Subtask 52-32-21-010-053-A
 C. Get Access 
R  **ON A/C 151-199,
R  (Ref. Fig. 403B/TASK 52-32-21-991-019-A) **ON A/C 401-499, 
R R  (Ref. Fig. 403C/TASK 52-32-21-991-019-C) **ON A/C 151-199, 401-499,
 (1) Remove the access panels 826AR, 826BR and 826CR from the cargo door. (2) Remove the lining and the insulation of the cargo door to get access to the upper end of the gear box (Ref. TASK 52-32-13-000-001). (3) Remove the vent door cover from the internal door structure to get access to the actuator arm of the vent door.
 (4) Remove the nuts (5), the washers (6) and the bolt (8) to disconnect the cover plate (7) from the inner side of the edge member. 

R 1EFF : ALL 1 52-32-21Page 421 1 1 Aug 01/05 1 1 1CES 1

 Access Panel and Protection Plugs
 Figure 403/TASK 52-32-21-991-019

R 1EFF : 001-049, 053-099, 101-105, 201-220, 1 52-32-21Page 422 1 1 Aug 01/05 1 1 1CES 1

 Access Panel and Protection Plugs Figure 403A/TASK 52-32-21-991-019-B
R 1EFF : 106-149, 221-299, 301-399, 1 52-32-21Page 423 1 1 Aug 01/05 1 1 1CES 1

 Access Panel and Protection Plugs
 Figure 403B/TASK 52-32-21-991-019-A 
R 1EFF :  151-199,  1  52-32-21 Page 424 
1  1  Aug 01/05
 1  1
 1CES  1

R  Access Panel and Protection Plugs 
R  Figure 403C/TASK 52-32-21-991-019-C 
R 1EFF :  401-499,  1  52-32-21 Page 425 
1  1  Aug 01/05
 1  1
 1CES  1

 **ON A/C ALL
 4. Procedure
_________ **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
 Subtask 52-32-21-020-052
 A. Removal of the Gear Box Linkage **ON A/C 001-049, 053-099, 101-105, 201-220,
 (Ref. Fig. 404/TASK 52-32-21-991-003) **ON A/C 151-199,
 (Ref. Fig. 404C/TASK 52-32-21-991-003-A) **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
 (1)
 Disconnect the drawbar (71) from the shaft lever (76) as follows:

 (a)
 Remove and discard the cotter pin (75) from the nut (74).

 (b)
 Remove the nut (74), the washers (73) and the bolt (72) from the shaft lever (76).

 (c)
 Remove the eye end of the drawbar (71) from the fork end of the shaft lever (76).

 (2)
 Disconnect the drawbar (71) from the actuator arm (107) of the vent door as follows:

 (a)
 Remove and discard the cotter pin (103) from the nut (104).

 (b)
 Remove the nut (104), the washers (105), the bush (106) and the bolt (108) from the actuator arm (107).

 (c)
 Remove the eye end of the drawbar (71) from the actuator arm (107).

R 1EFF : ALL 1 52-32-21Page 426 1 1 Aug 01/05 1 1 1CES 1

 Linkage of the Vent Door Mechanism
 Figure 404/TASK 52-32-21-991-003

R 1EFF : 001-049, 053-099, 101-105, 201-220, 1 52-32-21Page 427 1 1 Aug 01/05 1 1 1CES 1

 Linkage of the Vent Door Mechanism
 Figure 404A/TASK 52-32-21-991-003-C 
R 1EFF :  051-052,  1  52-32-21 Page 428 
1  1  Aug 01/05
 1  1
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門5(80)