Details of the Front-Spar Aft-Face (RIBS 22 thru 27)
Figure 609/TASK 57-21-00-991-011
1EFF : ALL 1 57-21-00Page 650 1 1 Nov 01/04R 1 1 1CES 1
Subtask 57-21-00-210-063
B. Inspection
(1)
Use a spark-free lamp to light the applicable inspection area and if necessary a mirror.
(2)
Examine the aft face of the front spar (ribs 22 thru 27). Make sure that:
-
there is no corrosion
-
there are no scratches, scores or damage
-
there are no loose or damaged fasteners
-the protective finish is in the correct condition.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 572100) for the
____
correct repair procedure.
5. Close-up
________ Subtask 57-21-00-410-057
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the applicable access panels (Ref. TASK 28-12-47-400-001) (Ref. TASK 28-12-45-400-002) (Ref. TASK 57-27-11-400-002) and (Ref. TASK 28-10-00-910-002):
-for the left wing, 550AB, 550BB, 550CB, 550DB, 560AB
-for the right wing, 650AB, 650BB, 650CB, 650DB, 660AB. Subtask 57-21-00-650-061
B. Fuel Configuration
(1) Refuel (Ref. TASK 12-11-28-650-003), defuel (Ref. TASK 28-25-00-650-001) or transfer fuel (Ref. TASK 28-25-00-869-001) as necessary.
Subtask 57-21-00-942-058
C. Removal of Equipment
(1)
Remove the warning notice(s).
(2)
Remove the safety barriers.
1EFF : ALL 1 57-21-00Page 651 1 1 Nov 01/04R 1 1 1CES 1
(3)
Remove the access platform(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 57-21-00Page 652 1 1 Nov 01/04R 1 1 1CES 1
TASK 57-21-00-200-010
R R Detailed Inspection of Outer Wing, Rear Spar Forward Face, between RIB8 and RIB11, including Top and Bottom Flanges
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND THE RELATED DOORS - COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______ GEAR.
1. Reason for the Job__________________
Refer to the MPD TASK: 572114-01
2. Job Set-up Information______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific No specific No specific 98D27803500001 safety barrierswarning noticesadjustable access platform 2 m (6 ft. 7 in.)1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R R Material No. 11-026 Material No. 19-003 GB DEF-STAN 68-148/1 SOLVENT GENERAL PURPOSE (Ref. 20-31-00)USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-11-28-650-003 Pressure Refuel with Automatic Control
28-10-00-910-001 Safety Procedures When You Do Work in a Fuel Tank
28-10-00-910-002 Access to the Fuel Tanks and the Work Areas
28-25-00-650-001 Pressure Defuel
28-25-00-650-003 To Drain Remaining Fuel from the Wing Tanks and the
Center Tank
28-25-00-869-001 Fuel Transfer
57-27-11-000-001 Removal of the Access Panel (540AB, 540BB, 540CB,
540DB, 540EB, 540FB, 540GB, 640AB, 640BB, 640CB,
640DB, 640EB, 640FB, 640GB)
57-27-11-400-001 Installation of the Access Panel (540AB, 540BB,
540CB, 540DB, 540EB, 540FB, 540GB, 640AB, 640BB,
640CB, 640DB, 640EB, 640FB, 640GB)
ASRM 572100 (for corrective action)
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼1(128)
